Using The Mounts - GoPro Hero4 Black User Manual

/ Camera Housing
PREVENTING WATER DAMAGE TO YOUR CAMERA
The rubber seal that lines the camera housing forms a waterproof barrier
that protects your HERO4 Black in wet and underwater conditions.
Keep the camera housing's rubber seal clean. A single hair or grain of
sand can cause a leak and damage your camera.
After every use in salt water, rinse the outside of the camera housing
with non-salt water and dry. Not doing this can eventually cause
corrosion of the hinge pin and salt buildup in the seal, which can
cause failure.
To clean the seal, rinse in fresh water and shake dry (drying with a
cloth may cause lint to compromise the seal). Re-install the seal into
the grooves in the backdoor of the camera housing.
WARNING: Failure to follow these steps each time you use
your GoPro can result in leaks that may damage or destroy your
camera. Water will damage both the camera and the battery,
which could cause an explosion or fire. Your warranty does not
cover water damage resulting from user error.
80
ATTACHING YOUR CAMERA TO MOUNTS
To attach your HERO4 Black camera to a mount, you need a Quick
Release Buckle, thumb screw or hardware depending on the mount
you are using. For more information on mounts, visit gopro.com/support.
Quick Release Buckle + Thumb Screw + Slim housing = Complete Unit
Quick Release
Thumb Screw
Buckle
Slim housing closed Swapping housing doors
USING CURVED + FLAT ADHESIVE MOUNTS
The Curved + Flat Adhesive Mounts make it easy to attach the camera
to curved and flat surfaces of helmets, vehicles and gear. Using the
Quick Release Buckle, the assembled camera housing can be clicked
on and off the secured Curved or Flat Adhesive Mounts.
Slim housing remove camera
Flat Adhesive Mount

/ Using the Mounts

Housing Complete Unit
Curved Adhesive Mount
81