SETTING THE WATCH FUNCTIONS
SETTING ANALOG TIME
1.
Gently pull the Crown outward until it clicks into place. The 'seconds hand' will
remain stationary.
2.
Rotate the Crown clockwise or counterclockwise to adjust the hands. The digital time can
be used as a reference for setting the analog time by pressing the T key.
3.
When the time is set, push the Crown back into the locked position.
SYNCHRONIZING ANALOG AND DIGITAL TIME FOR MATCHING 'SECONDS'
After setting the analog/digital 'hours' and 'minutes,' the last step is to synchronize the
'seconds.' There are two ways to adjust the analog and digital times so they operate in
unison:
IN DIGITAL SETTING MODE:
1.
Press and hold the T key for 3 seconds until the 'digital seconds' display flashes.
2.
Wait until the 'seconds hand' reaches zero.
3.
Once the 'seconds hand' reaches zero, press either the SC or HR key to reset the 'digital
seconds' display to "00".
10
SETTING THE WATCH FUNCTIONS
4.
The analog and digital times are now synchronized.
Tip: To confirm that the analog and digital seconds are synchronized, press the T key three
times. This will display the digital seconds and you can determine if you are synchronized.
5.
Press and hold the T key for 3 seconds to exit the setting mode.
IN ANALOG SETTING MODE:
1.
Gently pull the Crown outward until it clicks into place. The 'seconds hand' will remain
stationary.
2.
Press the T key three times to set the digital 'seconds' display.
3.
Use the 'digital seconds' display as a reference and wait until it matches with the
'seconds hand.'
4.
Once the 'digital seconds' and 'seconds hand' match, quickly push the Crown back into the
locked position.
5.
The analog and digital times are now synchronized. Check the setting by pressing the
T key three times to view the digital display and the second hand.
Note: If you take too long to match the settings, the minutes may not synchronize. If that
happens, you'll need to reset the minutes.
11