Troubleshooting - Bosch WTE86300US Operating, Care And Installation Instructions Manual

Troubleshooting

d
WARNING!
RISK OF ELECTRICAL SHOCK !
EXPLOSION HAZARD!
Repairs or replacement of parts
may be carried out by authorized
technicians only.
Problem
Dryer does not start. Dryer does not start.
Start/Stop" indicator light does not
illuminate. illuminate.
Program has been interrupted. Filter"
indicator light illuminates, a warning indicator light illuminates, a warning
signal is emitted and the display shows
F:01" or F:02".
Drum light does not function. Drum light does not function.
Start/Stop" indicator light does not Start/Stop" indicator light does not
illuminate. Wrinkle block/Finished"
indicator lights. indicator lights.
The display shows -0–".
Start/Stop" indicator light flashes and
the display shows F:03".
Degree of drying has not been reached
or the drying time is too long. or the drying time is too long.
Display may indicate F:04".
:04
Before calling the customer service,
d
check whether you can rectify the
fault yourself by means of the
following table.
If a fault cannot be rectified or
a repair is required:
Possible cause
Main plug not inserted at all or not inserted correctly. Insert main plug correctly.
A fuse of power supply has tripped.
Start/Stop" button not pressed.
Door not closed.
Ambient temperature below 41 °F/5 °C.
Lint filter dirty.
Fault in program sequence or malfunction.
The room/cabinet is not adequately ventilated.
No program selected.
Lightbulb defective, lightbulb burned out.
No power supply.
Fault in program sequence or malfunction. Fault in program sequence or malfunction.
Moisture sensor dirty.
Condensation outlet.
Laundry was too wet.
Unsuitable program selected.
Maximum drying time was exceeded.
Motor limit temperature was exceeded.
1. Set program selector to Off".
2. Turn off the circuit breaker.
3. Pull the mains plug out of the
socket.
4. Call customer service
(see page 22).
Remedial action
Replace/switch on fuse.
Press Start/Stop" button.
Close door.
Increase room temperature.
Clean filter as described on page 19.
Switch off/switch on again.
Switch off dryer, leave to cool down for 30 min,
switch on again. Restart program.
Provide an adequate supply of fresh air.
Switch off/switch on again.
Select program.
Change light bulb, see page 20.
Guarantee power supply.
Switch off dryer, leave to cool down for 30 min, Switch off dryer, leave to cool down for 30 min,
switch on again. Restart program.
Clean moisture sensor as described on page 20.
Switch off/switch on again.
Check hose for condensation outlet.
Spin laundry at higher speed in the washing
machine. Switch off/switch on again.
Select program with aid of the program selection
table (see page 26). Switch off/switch on again.
Clean lint filter (see page 19).
Check hose for condensation outlet.
Spin laundry at a higher speed in your washer.
Switch off dryer, leave to cool down for 30 min.
Switch on again. Start program.
21