8A. Turning The Machine Off / Rinsing; Coffee Preparation; 9A. Pre-Warm Cups; 9B. Brewing Coffee And Espresso - Jura Capresso Impressa 68193 Operating Instructions And Warranty

RINSING. The water will be caught in the drawer underneath.
The rinse cycle stops by itself and the display reads:
READY. You are now ready to make coffee.
*Note: S9 OT can be programmed to automatically start the
rinsing cycle after HEATING UP

8a. TURNING THE MACHINE OFF / RINSING

Before turning off the S9 OT, place containers under the Dual
Coffee Spouts and Auto Cappuccino System (Fig. 4).
When the S9 OT is turned off or turns itself off it will prompt for
short cleaning cycles as follows:
Only the Dual Coffee spouts were used: The S9 OT displays
MACHINE RINSING. For a few seconds hot water will be
dispensed through the Dual Coffee Spouts and through the
coffee spout of the Cappuccino section. The machine and the
display turn off.
The Auto Cappuccino Spouts and the Dual Coffee Spouts
were used: The S9 OT first displays
and the Rinse button illuminates. If the Rinse button is not
pushed within the next ten seconds, the display shows
RIGHT / PRESS RINSE. Press the Rinse button. The S9 OT will
dispense some hot water through the coffee spout of the
Cappuccino section. It will then push some hot water through
the Dual Coffee Spouts and turn off.
Please note: When the S9 OT turns off you may hear a slight
hissing noise.
COFFEE
is displayed (chapter 14.7).
CLEAN CAPPUCCINO
SPOUT

9. COFFEE PREPARATION

9a. PRE-WARM CUPS

In the morning pre-warm your cups with hot water through the
Hot Water Spout. Cold cups reduce the coffee temperature by
5º F to 10º F.
Place a cup under the Hot Water Spout, turn the Selector Dial
(Fig. 3.3) until the display shows
Selector Dial. The display shows
flow into your cup. Push the Selector Dial again to stop and
discard the water. COFFEE

9b. BREWING COFFEE AND ESPRESSO

The machine has four pre-set coffee buttons,
2 ESPRESSI, 1 COFFEE,
All buttons are pre-set for coffee strength, coffee volume and
temperature (chapter 5).
• Place one or two cups underneath the Dual Coffee Spouts
and push the desired button. The machine will grind, tamp
and then brew the coffee. It uses a 2-step brewing process
(pre-brew phase), pauses for a few seconds, and then starts
the brewing process. The display will show the name of the
button you pushed, e.g.
strength indicated by a bean graphic, e.g. 4 beans = strong.
Please note: when pushing any of the two-cup buttons, the
coffee strength is not displayed.
Important: After the brewing stops the machine will discard the
used coffee grounds. Please do not try to pull out the drawer
(Fig.1,18) during this operation. It can seriously damage the
machine.There is no need to pull out the drawer until the display
shows the message EMPTY TRAY
16.
HOT WATER and push the
TEMP. XHIGH and water will
READY.
1 ESPRESSO,
2 COFFEES (Fig. 2).
1 ESPRESSO and the selected coffee
or EMPTY GROUNDS.