Powering Down The Css; Troubleshooting The Css Hardware Components - Cisco 11500 Series Hardware Installation Manual

Powering Down the CSS

Powering Down the CSS

Troubleshooting the CSS Hardware Components

Cisco 11500 Series Content Services Switch Hardware Installation Guide
2-38
For a DC CSS, switch on the applicable circuit breakers for the power source.
•
Then on the CSS, toggle the power switch to the 1 (on) position.
See Figure 2-13
–
See Figure 2-15
–
each power supply. Power on all of the supplies in the CSS. The I/P OK
and DC OK LEDs light up on each power supply. If either LED remains
unlit, see the
this chapter.
The CSS starts the boot process. For information concerning the boot process on
the Cisco 11500 series CSS, refer to the Cisco Content Services Switch Getting
Started Guide.
To shut down the CSS gracefully and avoid introducing lost or fragmented files,
always use the shutdown command prior to removing power from the CSS.
For example:
(config-boot)# shutdown
Once the CSS shuts down all processes, you can remove power from the CSS.
This section provides general troubleshooting information for the CSS
components. It includes the following sections:
Troubleshooting the CSS 11501
•
Troubleshooting the CSS Modules
•
Troubleshooting the Console Interface
•
Troubleshooting the CSS Power Supply
•
Troubleshooting the CSS Fans
•
Information in this section applies to the CSS 11501, CSS 11503, and CSS 11506,
except where noted.
Chapter 2
for the location of the CSS 11503 DC power switch.
for the location of the CSS 11506 DC power switch for
"Troubleshooting the CSS Power Supply"
Cabling and Troubleshooting the CSS
section later in
78-17231-01