ADJUSTING THE STARTER CABLE/
CHECKING THE SPARK PLUG
3 - 21
ADJUSTING THE STARTER CABLE
1.Remove:
Seat
●
Fuel tank side panel (left)
●
2.Adjust:
*****************************************************
Adjustment steps:
●
Disconnect the starter cable 1 from the car-
buretor body.
NOTE:
Do not remove the starter plunger 2 from the
starter cable.
●
Measure the starter plunger stroke distance
a of the starter lever 3 fully close to fully
open position. If the distance is out of specifi-
cation adjust it as described below.
Starter plunger stroke distance:
15 mm (0.59 in)
È Fully closed position
É Fully open position
●
Pull back the boot 4.
●
Loosen the locknut 5.
●
Turn the adjuster 6 in or out until the correct
distance is obtained.
Turning in
Distance increased.
Turning out Distance decreased.
●
Tighten the locknut 5.
●
Push in the boot 4.
●
Connect the starter cable to the carburetor.
WARNING
After adjusting the cable, turn the handle-
bar to right and left, and make sure that the
engine idling speed dose not increase.
*****************************************************
3.Install:
Fuel tank side panel (left)
●
Seat
●
CHK
ADJ