Dodge 2011 Charger User Manual page 12

GETTING STARTED
NOTE:
• If "Unlock All Doors 1st Press" is programmed all doors will unlock when you grab
hold of the front driver's door handle. To select between "Unlock Driver Door 1st
Press" and "Unlock All Doors 1st Press", refer to the Uconnect Touch™ Settings in
your vehicle's Owner's Manual on the DVD or Programmable Features in this guide for
further information.
• If "Unlock All Doors 1st Press" is programmed all doors and trunk will unlock when
you press the trunk button. If "Unlock Driver Door 1st Press" is programmed only the
trunk will unlock when you press the trunk button. To select between "Unlock Driver
Door 1st Press" and "Unlock All Doors 1st Press", refer to the Uconnect Touch™
Settings in your vehicle's Owner's Manual on the DVD or Programmable Features in
this guide for further information.
• If a Key Fob is detected in the vehicle when locking the vehicle using the power door
lock switch, the doors and trunk will unlock and the horn will chirp three times. On
the third attempt, your Key Fob can be locked inside the vehicle.
• After pressing the Keyless Enter-N-Go LOCK button, you must wait 2 seconds before
you can lock or unlock the vehicle using the door handle.
• If a Keyless Enter-N-Go door handle has not been used for 72 hours, the Keyless
Enter-N-Go feature for that handle may time out. Pulling the deactivated front door
handle will reactivate the door handle's Keyless Enter-N-Go feature.
To Enter the Trunk:
• With a valid Keyless Enter-N-Go Key Fob located outside the vehicle and within
3 ft (1.0 m) of the deck lid, press the button on the left side of CHMSL, (Center
High Mounted Stop Light) which is located on the deck lid.
NOTE:
• Refer to your Owner's Manual on the DVD for further information.
Engine Starting/Stopping
• To stop the cranking of the engine prior to the engine starting, press the button
again.
10
Starting
• With a valid Keyless Enter-N-Go Key
Fob inside the vehicle.
• Place the shift lever in PARK or
NEUTRAL.
• While pressing the brake pedal, press
the ENGINE START/STOP button once.
If the engine fails to start, the starter
will disengage automatically after
10 seconds.