Tires/Wheels - Mercedes-Benz E-Class Operator's Manual

Wheel and tire combinations
400
Clean the wheel and wheel hub contact
X
surfaces.
Slide the wheel to be mounted onto the
X
alignment bolt and push it on.
Tighten the wheel bolts until they are
X
finger-tight.
Unscrew the alignment bolt.
X
Tighten the last wheel bolt until it is finger-
X
tight.
Vehicles with a collapsible spare
X
wheel: inflate the collapsible spare wheel
( page 412).
Y
Only then lower the vehicle.
Lowering the vehicle
G
WARNING
The wheels could work loose if the wheel nuts
and bolts are not tightened to the specified
tightening torque. There is a risk of accident.
Have the tightening torque immediately
checked at a qualified specialist workshop
after a wheel is changed.
! Vehicles with a collapsible spare
wheel: before lowering the vehicle, inflate
the collapsible spare wheel with the tire
inflation compressor. The wheel rim could
otherwise be damaged.
Tightening the wheel nuts (example: vehicle with
an emergency spare wheel)
Turn the crank of the jack counter-
X
clockwise until the vehicle is once again
standing firmly on the ground.
Place the jack to one side.
X
Tighten the wheel bolts evenly in a
X
crosswise pattern in the sequence
indicated (: to A). The specified
tightening torque is 96 lb-ft(130 Nm).
Turn the jack back to its initial position.
X
Stow the jack and the rest of the vehicle
X
tools in the trunk/cargo compartment
again.
AMG vehicles and vehicles with AMG
X
equipment: insert the cover into the outer
sill.
Check the tire pressure of the newly
X
mounted wheel and adjust it if necessary.
Observe the recommended tire pressure
( page 376).
Y
i
Vehicles with tire pressure monitor: all
wheels mounted must be equipped with
functioning sensors.
Wheel and tire combinations
General notes
! For safety reasons, Mercedes-Benz
recommends that you only use tires and
wheels which have been approved by
Mercedes-Benz specifically for your
vehicle.
These tires have been specially adapted for
use with the control systems, such as ABS
®
or ESP , and are marked as follows:
MO = Mercedes-Benz Original
R
MOE = Mercedes-Benz Original Extended
R
(tires featuring run-flat characteristics)
MO1 = Mercedes-Benz Original (only
R
certain AMG tires)
Mercedes-Benz Original Extended tires
may only be used on wheels that have been
specifically approved by Mercedes-Benz.
Only use tires, wheels or accessories
tested and approved by Mercedes-Benz.
Certain characteristics, e.g. handling,
vehicle noise emissions or fuel
consumption, may otherwise be adversely