Device Replacement And Specifications - Honeywell THX9321 Prestige 2.0 System Installation Manual

System Installation Guide
Replacing system components
To replace an Equipment Interface Module (EIM)
Follow steps below to disconnect the thermostat and RedLINK accessories.
See pages 5-6 to re-link devices.
At the Thermostat
1 Press MENU > INSTALLER OPTIONS, then enter date code when prompted (printed on
back of thermostat). Or press MENU > EQUIPMENT STATUS to find the date code.
2 Scroll down to select WIRELESS DEVICE MANAGER.
3 Press REMOVE DEVICE, then select THIS THERMOSTAT to remove.
At the Portable Comfort Control
1 Press and hold the blank space (or arrow if present)
in the lower right hand corner of the screen until the
display changes.
2 Press REMOVE, then YES to disconnect from the old EIM.
At the Indoor Sensor, RedLINK Internet Gateway, Entry/Exit Remote, Vent Boost
Remote or TrueSTEAM Wireless Adapter
Press and hold the CONNECT button on the RedLINK accessory until the status light glows
amber (hold for about 10 seconds). This will disconnect the device from the old EIM or ther-
mostat.
To replace a thermostat
At the EIM (Skip this step if no EIM is used)
Press and hold the CONNECT button on the EIM until the status light glows amber (hold for
about 10 seconds). This will disconnect ALL devices from the EIM.
At the Portable Comfort Control
1 Press and hold the blank space (or arrow if present) in the lower right hand corner of
the screen until the display changes.
2 Press REMOVE, then YES to disconnect from the old thermostat.
At the Indoor Sensor, RedLINK Internet Gateway, Entry/Exit Remote, Vent Boost
Remote or TrueSTEAM Wireless Adapter
Press and hold the CONNECT button on the RedLINK accessory until the status light glows
amber (hold for about 10 seconds). This will disconnect the device from the old thermostat.
To remove accessories from an EIM or thermostat
At the Thermostat
1 Press MENU > INSTALLER OPTIONS, then enter date code when prompted (print on back
of thermostat). Or press MENU > EQUIPMENT STATUS to find the date code.
2 Scroll down to select WIRELESS DEVICE MANAGER.
3 Press REMOVE DEVICE, then select the device you want to remove.
OR: At the EIM
Press and hold the CONNECT button on the EIM until the status light glows amber (hold for
about 10 seconds). This will disconnect ALL devices from the EIM.
If the THX9321 thermostat is setup without an EIM, all thermostat settings must be reset before it can be used with an EIM.
Press MENU > INSTALLER OPTIONS, scroll down to select ADVANCED OPTIONS, then press RESTORE FACTORY
DEFAULTS.
69-2490—05
26
Press and hold
in lower right
corner of screen
MCR32958A