Toyota 2007 YARIS HATCHBACK Owner's Manual page 434

05 12.06
(b) Normal driving
1. Start the engine as instructed in "How
to start the engine" in Section 3. The
transmission must be in "P" or "N".
2. With your foot holding down the brake
pedal, shift the selector lever to "D".
When the lever is in the "D" position, the
automatic transmission system will select
the most suitable gear for running condi-
tions such as normal cruising, hill climb-
ing, hard towing, etc.
Always use the "D" position for better fuel
economy and quieter driving. If the engine
coolant temperature is low, the transmis-
sion will not shift into overdrive gear even
in the "D" position.
CAUTION
Never put your foot on the accelera-
tor pedal while shifting.
3. Release the parking brake and brake
pedal. Depress the accelerator pedal
slowly for smooth starting.
118
(c) Using engine braking
To use engine braking, you can downshift
the transmission as follows:
D
Shift into the "3" position. The trans-
mission will downshift to third gear and
engine braking will be enabled.
D
Shift into the "2" position. The trans-
mission will downshift to second gear
when the vehicle speed drops down to
or lower than 86 km/h (53 mph), and
stronger engine braking will be en-
abled.
D
Shift into the "L" position. The trans-
mission will downshift to first gear
when the vehicle speed drops down to
or lower than 43 km/h (26 mph), and
maximum engine braking will be en-
abled.
CAUTION
Be careful when downshifting on a
slippery surface. Abrupt shifting
could cause the vehicle to skid or
spin.
(d) Using "2" and "L" positions
The "2" and "L" positions are used for
strong engine braking as described pre-
viously.
With the selector lever in "2" or "L", you
can start the vehicle in motion as with the
lever in "D".
With the selector lever in "2", the vehicle
will start in first gear and automatically
shift to second gear.
With the selector lever in "L", the trans-
mission is engaged in first gear.
2007 YARIS S/D from Jan. '06 Prod. (OM52646U)