Delay Wash - GE GFWS1705 Owner's Manual & Installation Instructions

8
9
10
or
(depending on model)
11
or
(depending on model)
PreWash
(on some models)
Prewash is an extra wash before the
main wash. Use it for heavily soiled
clothes or for clothes with a care
label that recommends prewashing
before washing. Be sure to add liquid
or powder high-efficiency detergent,
or the proper wash additive to the
prewash dispenser.
Time Saver
(on some models)
Use this option to reduce the overall
wash cycle by at least 20% without
sacrificing wash performance. This
feature is available on all cycles except
Basket Clean, Sanitize, Rinse + Spin,
and Quick Wash.
This option will modify the wash cycle,
slightly raising the wash temperature
and using more water to deliver equal
wash performance as the basic cycle. All
other features, such as Extra Rinse, Add
Steam, etc, can be used with Time Saver
but may adjust the total wash time.

Delay Wash

You can delay the start of a wash cycle
for up to 24 hours. Press the Delay
Wash button to choose the amount
of time you want to delay the start of
the wash cycle. Once the desired time
is reached, press the Start button. The
machine will count down and start
automatically at the correct time.
Extra Rinse
This option allows for an extra rinse
during a cycle to remove excess dirt
and detergent from soiled loads.
GEAppliances.com
PreWash must be selected prior to
pressing Start.
The PreWash feature will fill the washer
with cold water (adding the prewash
detergent), tumble the clothes, drain
and spin. Then the washer will run the
selected wash cycle.
NOTE: In some special cycles, the
prewash is selected automatically
as the default. You can modify this
selection at any time.
To use:
1. Turn power on and select a wash
cycle which has Time Saver as an
option.
2. Make any adjustments to Soil, Temp
and Spin as desired.
3. Press the Time Saver button to
reduce the overall wash time.
4. Press the Start/Pause button.
NOTE: If you forget to fully close the
door, a reminder signal will beep
reminding you to do so.
NOTE: If you open the door when the
delay is counting down, the machine
will enter the pause state. You must
close the door and press Start again in
order to restart the countdown.
On models with Rinse & Spin cycle, a
drain and spin cycle can be achieved by
pressing the Extra Rinse button until the
light is no longer illuminated.
On models with Drain+Spin cycle, a
rinse and spin cycle can be achieved by
selecting Extra Rinse option.
7