Advertisement
Quick Links
CD Changer Installation Instructions for:
1999 BMW 5 Series Sedan (E39)
In Factory Left-Rear Trunk Area
Part Description
Main CD-C bracket
Main base bracket
M5x14 bolt
Clip nuts
Screw
Cap nut
Nylon insert nut
CD sub bracket
Product & Service Engineering Dept.
www.bmwpost.ru/forum
UPDATE: 12/98
Mounting of CD Changer
Current E39 Kit P/N
82 11 1 469 911
65 12 8 371 137
65 12 8 361 452
07 11 9 915 113
61 13 1 372 033
07 11 9 916 946
51 71 1 934 930
63 17 1 367 868
65 12 8 371 136
Installation Instruction P/N 99 00 0 001 756
BMW of North America, Inc.
December 1998
New E39 Kit P/N
QTY
82 11 1 469 911
1
85 12 8 361 453
1
65 12 8 361 452
6
07 11 9 915 113
6
61 13 1 372 033
1
07 11 9 916 946
2
51 71 1 934 930
1
63 17 1 367 868
1
N/A
QTY
1
1
3
3
1
2
1
0
Advertisement
Related Manuals for BMW Sedan 5 Series 1999 Cd Changer
Summary of Contents for BMW Sedan 5 Series 1999 Cd Changer
- Page 1 UPDATE: 12/98 CD Changer Installation Instructions for: 1999 BMW 5 Series Sedan (E39) Mounting of CD Changer In Factory Left-Rear Trunk Area Current E39 Kit P/N New E39 Kit P/N Part Description 82 11 1 469 911 82 11 1 469 911...
-
Page 2: General Information
INTRODUCTION These installation instructions were produced to give the installation technician all necessary information to properly install the BMW CD Changer in the left side rear trunk area in all E39 sedan vehicles. These instructions were developed by the Product and Service Engineering Department of BMW of North America, Inc. -
Page 3: Pre-Installation
www.bmwpost.ru/forum PREINSTALLATION All vehicles with factory pre-wiring should have the CD audio cable inserted into the (17 pin) Radio Connector. Before starting installation of the CD changer, check that the CD audio cable is secured in place with the Lock Pin (see Figure 1) CD CHANGER PREPARATION Shipping screws are installed on the bottom of... -
Page 4: Installation
To protect the Spring Pin, cover the Pin area with the supplied Pin Label by aligning the two diagonally opposite holes with H and V positions (see Figure 4). INSTALLATION Attach the mounting bracket to the CD Changer using the mounting hardware (M4) shipped with the CD Changer. -
Page 5: Final Installation
Connect CD audio and Power/I-Bus cables to CD changer (see Figure 7). First, install a M5 bolt to front threaded body nut loosely. Then, install 4 other bolts to remaining 4 body nuts (see Figure 8). 10. Remove tray pocket from CD changer Trunk Trim Cover and place CD changer trunk trim bezel over CD changer (See Figure 9).