Start And Stop - Jonsered 630 Operator's Manual

Start and stop

!
WARNING!
• Never start the saw engine without the bar, chain and
clutch cover (chain brake) assembled - or else the
clutch can come loose and cause personal injuries.
• Always move the saw away from the fueling area
before starting.
• Place the saw on clear ground and make sure that the
chain is not contacting anything. Also, make sure that
you have a secure footing.
• Keep people and animals well away from the working
area.
Cold engine
CHAIN BRAKE:
Disengage the chain brake by
pulling the hand guard
towards the front handle.
IGNITION:
Move the ignition switch to
startposition.
CHOKE:
Set the choke control in choke
position.
FAST IDLE:
Combined choke/fast idle is
received when the choke is
moved to choke position.
Warm engine
Use the same procedure as
for starting cold engine but
without choke. Fast idle is
recived by first set the choke
control in choke position, and
then back again.
28
– English
START AND STOP
Start
Grip the front handle with your
left hand and hold the saw
down by putting your right foot
in the rear handle. Pull the
starter handle with your right
hand and pull out the starter
cord slowly until the starter
pawls engage. Then pull
sharply.
Push in the choke control
immediately when the engine
ignites and make repeated
starting attemps. When the
engine starts, rapidly give full
throttle. Then the throttle latch
will disengage.
CAUTION! Do not release the
starter handle from fully pulled
out position as this can cause
damage on the saw.
Stop
The engine is stopped by
switching off the ignition.
(Move the ignition switch to
stopposition.)