Installing On A Wall - GE 30234 User Manual

Getting started
The unit is properly installed if you pick up the handset and hear a dial tone.
If you do not hear a dial tone, re-check all installation steps.

Installing on a wall

1. Make sure the rotating handset tab is in
the WALL position (see page 3) and
batteries have been properly installed.
2. Plug one end of the telephone line cord
into the LINE jack at the top of the base.
Please Note: If you have DSL high speed
Internet service, a DSL filter is required
(not included). Contact your DSL service
provider for more information about
DSL filters.
3. Close the kick-stands on the bottom of
the base.
4. Thread the line cord through the groove as shown and plug the end into
the modular telephone jack. Excess telephone line can be tucked into the
recessed area at the bottom of the telephone base.
5. Slip the mounting holes (on the bottom of the base) over the wall plate
posts on the modular jack and slide the unit down firmly into place.
6. Plug the power adapter into the jack engraved "9V DC" at the top of the
base, then plug the other end into an electrical outlet not controlled by a
wall switch.
7. Plug one end of the handset coiled cord into the bottom of the handset
(near the mouthpiece) and the other end of the cord into the handset jack
(on the left side of the base), then place the handset onto the base cradle.
8. Adjust the VOLUME buttons (
the RINGER VOLUME switch to the desired setting: HI, LOW or OFF. You
can also adjust the pitch of the ringer by setting the RINGER PITCH switch
(HIGH/LOW). The unit is properly installed if you pick up the handset and
hear a dial tone. If you do not hear a dial tone, re-check all installation
steps.
/ ) to the desired listening level. Adjust
7