Sundance Spas Altmar Owner's Manual page 84

880 SERIES
PROBLEM
Poor jet
action
(Sections
9.4-9.25,
pages 25-46)
Water is too
hot
No heat
Filter/
circulation
pump off
Should checking the above steps fail to correct the problem, please call
your authorized dealer so that he may arrange service.
Sundance builds the best hot tubs in the industry. Nonetheless, we are
always striving to improve the quality and features of our products. Your
input as a Sundance hot tub owner is a cherished part of this process. If
you have any comments or suggestions, or if you wish to be informed on
any new products for your hot tub, please write to us.
CONGRATULATIONS on your good taste and welcome to the happiest
and most relaxed family in the world!
Page 78
PROCEdURE
1. Make certain the jets pump is turned on.
2. Check position of massage selectors.
3. Open air control for selected jet system.
4. Check for adequate water level.
5. Check for dirty filter (pages 61-62).
1. Reduce thermostat setting (page 18).
2. Switch hot tub to "Economy" mode to turn heater on
only during programmed filter cycles (page 55).
1. Check thermostat setting.
2. Keep the cover in place while heating.
3. If "heater on" indicator is lit but no temperature rise is
experienced after a reasonable period of time, con-
tact your Sundance Spas dealer or qualified service
technician.
1. Verify filter/circulation pump is programmed to run 8
hours a day (page 55).
2. Filter/circulation pump cycle canceled by power
interruption. Wait 24 hours for hot tub to reset or
press select button for manual activation.
3. Hot tub water is warmer than 95°F (35°C) and two
degrees warmer than the set temperature. The
"Summer Logic" safety feature has activated. See
note on page 56 for details.