Bernina artista 200 Embroidery Owner's Manual page 4

M
ASTERING
Y
OUR
BERNINA
®
Details of the Module
Owner's manual pg.__
Standard Accessories
Owner's manual pg.___
Special Accessories
Owner's manual pg.___
Module Set Up
Owner's manual pg.___
• Module Connection Cable
- Stored on the bottom back edge of the module
- Make sure the FLAT side of the cable is to the FRONT
- REMEMBER, your sewing/embroidery computer is Microsoft Windows powered, so your module has
"Plug and Play" capabilities. There is NO NEED to turn your sewing/embroidery computer OFF to
connect your module.
• Attaching the Module
- Remember that both your sewing/embroidery computer and the module MUST be on a flat surface to
properly complete embroidery
- Place the module on the machine behind the free arm
- Slide the module on from the left until the lugs engage in the base plate
• Removing Module
- Remove the cable plug from the sewing/embroidery computer
- Lift slightly and slide the module to the left to remove it from the machine
Prepare for Embroidery
Owner's manual pg.___
• Presser Foot
- Embroidery Foot #15 comes with the module
- Attach the foot to the machine
• Needles - Owner's manual pg.____
- Use the proper needle for the thread and fabric being used
- Insert a new needle at the beginning of each project
- Needle should be in the highest position when attaching the hoop
• Straight Stitch Plate (optional accessory)
- While embroidering, the needle only moves up and down. There is no sideways movement. The hoop
is what moves. By using the Straight stitch plate, the quality of your embroidery can be improved.
• Bobbin
- Use the Gold Latch bobbin case with the "pigtail". When threading the bobbin into the case, finish the
threading process by threading the bobbin thread through the wire loop.
- Remember to ONLY use high quality lightweight bobbin thread for your embroidery projects.
BERNINA
M Y
ASTERING OUR
BERNINA
artista 200 Embroidery Beginnings
®
9/1/02 S
®
artista 200 Embroidery
SECTION A
A
ECTION
artista 200 Embroidery/4