Automatic Function F2 (Cooking) - John Lewis JLBICO2 Instruction Manual

Programme
A 03
A 04
Important Notes:
• Always use dishes for use in the microwave
oven and a lid or cover to avoid loss of
liquids.
• Stir or mix the foods several times during
heating, especially when the oven emits a
beep and the display is flashing as follows: .
• The time required to heat the food will
depend on its initial temperature. Food
taken straight from the fridge will take
longer to heat up than food that is at room
temperature. If the food temperature is not
suitable, select a greater or lesser weight
next time you heat up the food.
• After heating, stir the food or shake the
container and then leave the food to stand
for some time to allow the temperature to
become uniform throughout the food.
Warning! After heating the container
may be very hot. Although
microwaves do not heat up most
containers, these may heat up through
heat transmission from food.
Automatic function F2
(cooking)
Use this function to cook fresh food
Programme
B 01
Food
Pre-prepared
dishes e.g. goulash
Vegetables
Food
Potatoes
Weight (Kg)
200 - 1500
200 - 1500
1. Select the Automatic function F2 with the
Function selection keys.
2. Select the Program with Parameter
selection keys. The Duration and Clock
symbols and the display start blinking.
3. Set the program with the '+' and '–' keys
(refer to the table below).
4. Press the Confirmation key to validate the
program. The display and symbols stop
blinking.
5. Select the Weight with Parameter
selection keys. The Weight symbol and
display start blinking.
6. Set the weight with the '+' and '–' keys.
7. Press the Confirmation key to validate the
weight. The display and symbol stop
blinking.
8. Start the cooking process by pressing the
Start key.
The following table shows the Automatic
Function F2 programmes, indicating weight
intervals, and defrosting and standing times (in
order to ensure the food is of a uniform
temperature).
Weight (Kg)
200 - 1000
18
Time (min)
3 - 18
2,6 - 14
Time (min)
4 - 17
Standing time
(min)
Turn 1-2 x, keep
covered, 1-2 min.
Turn 1-2 x, keep
covered, 1-2 min.
Standing time
(min)
Turn 1-2 x, keep
covered, 1-2 min.