Video Output Formats; Dip Switch Settings For Video Output Formats; Line Voltage Frequency - TANDBERG C20 Administrator's Manual

Quick Set C20/C20plus
Contents Introduction
Contents Introduction
The PrecisionHD 1080p 4x/12x
camera,
cont...

Video output formats

The TANDBERG Quick Set is available in two versions:
The TANDBERG Quick Set C20 is delivered with a PrecisionHD
1080p 4x zoom with 1080p30 maximum resolution.
The TANDBERG Quick Set C20plus is delivered with a
PrecisionHD 1080p 12x zoom with 1080p60 maximum resolution.
This section describes how to set the DIP switches 1–5 to configure
the TANDBERG PrecisionHD 1080p camera for different video output
formats.

DIP switch settings for video output formats

The video output format for the camera is set by DIP switches. The
DIP switches are found on the bottom side of the camera.
The default setting is Auto. When using HDMI, the video output format
is automatically detected. See the table to the right.
Maximum resolution for HDMI is 1080p60 for PrecisionHD 1080p
12x and 1080p30 for PrecisionHD 1080p 4x
Maximum resolution for HD-SDI is 1080p30.

Line voltage frequency

The camera will automatically detect the line voltage frequency when it
is 50 or 60 Hz. You may set the video output format to a specific value
(use the DIP switches) to override the auto frequency detection, if a
different line voltage frequency is an issue.
D14489.01—JULY 2009
Getting started About the menus
Getting started About the menus
The DIP switch
Bottom side of the TANDBERG
PrecisionHD 1080p camera
Advanced settings Settings library
Advanced settings Settings Library
1
0
Administrator Guide
Cameras Appendices
Cameras Cameras Appendices
DIP Switch table for video formats
1 2 3 4 5 HDMI
0 0 0 0 0
0 0 0 0 1 1920x1080p25
0 0 0 1 0 1920x1080p30
0 0 0 1 1 1920x1080p50 *
0 0 1 0 0 1920x1080p60 *
0 0 1 0 1 1280x720p25
0 0 1 1 0 1280x720p30
0 0 1 1 1 1280x720p50 *
0 1 0 0 0 1280x720p60 *
0 1 0 0 1 Software control
The table shows the different settings available for the HDMI and
the HD-SDI outputs.
Auto: Camera negotiates format over HDMI. HD-SDI tracks HDMI
and defaults to 1080p30 in absence of HDMI sync.
Software: For more on the Software control setting, read about
video mode selections in the TANDBERG PrecisionHD 1080p User
Guide.
* Do not apply to the PrecisionHD 1080p 4x camera
Contact us
Contact us
HD-SDI
Auto
1920x1080p25
1920x1080p30
1280x720p50 *
1280x720p60 *
1280x720p25
1280x720p30
1280x720p50 *
1280x720p60 *
40