Stylistic St5000 Tablet Pc Features; Hardware Features; Pc Card Support; Internal Modem - Fujitsu Stylistic ST5000 Series Technical Reference Manual

Chapter 1

Stylistic ST5000 Tablet PC Features

This chapter provides an introduction to the Stylistic ST5000 Tablet PC system hardware and software and gives an
overview of some of the Tablet PC's features. Detailed specifications on the features discussed in this chapter are
given in other chapters of this guide.
The Stylistic ST5000 computer series is designed for the Microsoft Windows XP Tablet PC Edition. The system uses
an active digitizer and conforms to the Windows Tablet PC standards.
The Stylistic ST5000 Tablet PC system has been tested by Windows Hardware Quality Labs (WHQL) at Microsoft
Corporation and is compliant with PC2001 system design guidelines.

Hardware Features

PC Card Support

The Stylistic ST5000 Tablet PC is equipped with a PC Card slot that allows you to install a Type I or II PC Card. The
PC Card slot is compliant with PC CardBus Standard Release 3.0 and provides support for the following PC Card
features:
• Multivoltage 3.3/5 V PC Cards (detected automatically)
• CardBus (PCI bridge) type PC Cards
• Supports PCIC (PC Card I/O Card) protocol
• Backward compatibility with previous PC Card Standard Release level PC Cards

Internal Modem

The Stylistic ST5000 Tablet PCs are equipped with an internal 56 Kbps* modem. (Note: The 56 Kbps rate is nominal;
due to FCC restrictions, actual rates are limited to 53 Kbps.)
For details on the built-in modem, see "Internal Modem Specifications" on page 34.

Internal LAN

The Stylistic ST5000 Tablet PCs are equipped with an internal wired 10/100/1000* Base-T/Tx Ethernet LAN.
*1000 Mbps, commonly referred to as Gigabit Ethernet.

ACPI Support

The Stylistic ST5000 Tablet PC supports the Advanced Configuration and Power Interface (ACPI) Specification,
revision 1.0, in all system configurations. With ACPI, power management features are controlled and configured
primarily by the BIOS and BIOS settings. The ACPI specifications allow for additional control over power
management features such as state transitions and device timeouts. Refer to the ACPI specifications and the
documentation for your operating system regarding power management with ACPI.

DMI Support

The Stylistic ST5000 supports the Distributed Management Interface (DMI). DMI provides a framework for managing
the variety of components within the tablet PC. The Event Logging menu in the BIOS allows you to configure the
DMI event logging options (see "Event Logging Submenu" on page 19).
1
1
1
1
1
1
3