Yamaha MT8X Operation Manual page 19

Rehearsal
8. Press the PLAY button to start the rehearsal. The PLAY and REHE indicators illuminate.
9. Adjust the channel fader, PAN control and equalizer controls for each channel. If necessary, add an effect
and adjust its level for each channel.
10. Adjust the recording level using the corresponding GROUP MASTER controls. (See "MONITOR" on
page 14.)
1 1. Press the RTZ button to finish the rehearsal and rewind the tape.
Recording
12. Press the REC/PAUSE button. The REC/PAUSE indicator illuminates.
13. Press the PLAY button to start recording. The PLAY indicator illuminate.
14. When recording is finished, press the RTZ button to stop and rewind the tape. The PLAY and REC/PAUSE
indicators go out and the REC select indicator
Checking the finished recording
For monaural ping-pong recording
15. Release the GROUP switch under MONITOR SELECT and press CUE.
16. Slide up the CUE LEVEL control for the recorded track.
17. Press the PLAY button to play back the tape, and check the contents of the recording.
18. If the recording needs to be redone, repeat steps 4-17.
For stereo ping-pong recording
15. Release the GROUP switch under MONITOR SELECT and press STEREO.
16. Set the input selector switches to the TAPE position for the channels which correspond to the recorded tracks,
and set the channel faders at about 7-8. (Channels 5 and 6 for the example.)
Also, adjust the orientation of signals by using the PAN controls. (Set the channel 5 to "L" and channel 6 to "R"
for the example.)
17. Set the input selector switches (which were set to the TAPE position in step 1) to the MIC/LINE (or LINE)
position.
18. Press the PLAY button to play back the tape, and check the contents of the recording.
19. If the recording needs to be redone, first set the input selector switches (which were set to the TAPE position in
step 16) to the MIC/LINE (or LINE) position, secondly, set the input selector switches (which were set to the
MIC/LINE (or LINE) position in step 17) to the TAPE position, and then repeat the procedures in steps 4-18.
18
on the display flashes.