What To Do If - Bosch Washing machine Instruction Manual

What to do if ...

Water is leaking out. – Attach/replace the drainage hose correctly.
– Tighten the screw connection of the supply hose.
No water supply. – Start/Pause
– Tap not turned on?
Detergent not dispensed.
– Filter blocked? Clean the filter –> page 10.
– Supply hose kinked or trapped?
Washing machine door – Safety function active. Wait approx. 2 minutes.
cannot be opened. – Is Spülstop (Rinse Hold, without final spin) selected? –> page 3, 4.
Programme does not – Start/Pause
– Washing machine door closed?
start.
Detergent solution is not – Is Spülstop (Rinse Hold, without final spin) selected? –> page 3, 4.
drained. – Clean the detergent solution pump –> page 10.
– Clean the waste pipe and/or drainage hose.
Water not visible in the – Not a fault - water below the visible area.
drum.
Unsatisfactory spin – Not a fault - the unbalanced-load detection system has cancelled
the spin cycle because of uneven distribution of the laundry.
result.
Distribute small and large items of laundry evenly inside the
Laundry wet/too damp.
drum.
– Easy-iron selected? –> page 5.
– Too low a speed selected? –> page 5.
Spin cycle performed – Not a fault - unbalanced load detection system adjusts the
several times. imbalance.
Residual water in the – Not a fault - the action of the care product is not affected.
– Clean the insert if necessary –> page 9.
compartment for care
products.
Odour formation in the – Run programme
standard detergent.
washing machine.
Foam escaping from the – Too much detergent used?
detergent drawer. If foam is escaping from the detergent drawer:
Mix 1 tablespoon of fabric softener with ½ litre of water and pour
into compartment II (not with outdoor or down fabrics).
– Reduce the detergent dosage for the next wash cycle.
Intense noise formation, – Are the appliance feet fixed?
Secure the appliance feet –> Installation instructions.
vibrations and "walking"
– Transportation safety devices removed?
during the spin cycle.
Remove the transportation safety devices –> Installation
instructions.
The indicator lights do – Power cut?
– Fuses tripped? Reset/change the fuse.
not function during
– If the fault occurs repeatedly, call the after-sales service.
operation.
Programme sequence – Not a fault - unbalanced load detection system adjusts
longer than usual. imbalance by repeatedly distributing the laundry.
– Not a fault - foam detection system active - adds an additional
rinse cycle.
Detergent residues on – Occasionally, phosphate-free detergents contain water-insoluble
the laundry. residues.
– Select
If you cannot correct a fault yourself or a repair is required:
– Turn the programme selector to Off and remove the mains plug from the socket.
– Turn off the water supply and call the after-sales service –> Installation instructions.
not selected?
selected?
Cottons 90 °C without laundry. Use
Rinse/ Spin or brush out the laundry after washing.
Observe the safety instructions on page 8.
Read these instructions and the separate installation instructions before
operating the washing machine.
11
Washing machine
Instruction manual en