Download Print this page

Whirlpool TRASH MASHER Installation Iinstructions page 4

Advertisement

To change
the front
panel
color:
1.
2.
Remove the drawer from the unit. (See Step 3 of
the Installation
Instructions.)
Remove handle by removing the screws at the top
inside of the drawer.
3.
4.
Remove one spacer.
Remove outside front panel by carefully pulling it
up.
5.
Select the color you wish to have showing
and
carefully
push the panel back in the front of the
drawer trim.
6.
7.
Replace the spacer.
Replace the handle with the screws removed in
Step 2. above.
8.
Replace the drawer.
I
CAUTION:
REPLACE HANDLE BEFORE OPERATING
COMPACTOR TO AVOID INJURY FROM MOVING PARTS. I
CUSTOM
DECORATING
In place of the panel pack, you may use a
114"
thick
wood panel to match your cabinets or other suitable
decorative
material. See Figure 75.
To do so:
1.
Follow Steps 1 through 4 under Changing
Panel
Color. Also remove all cardboard.
2.
Slide decorative
panel between trim pieces.
3.
~rmro~endt handle
with
the
screws
previously
4.
Slide the drawer into the unit
5.
Paint, wallpaper, fabric, etc., can be applied directly
to one of the panels.
1
22-15/16"
1
' _
l&5/8"-
'
FIGURE 15
BEFORE YOU CALL FOR SERVICE
If your compactor
does not seem to be operating
properly, check the following
before calling for service.
If the compactor
won't
operate:
l
Is the electric cord securely plugged in?
9 Have you checked the main fuse or circuit breaker box?
.
Is the drawer completely
closed?
l
Is the key-knob turned all the way to START before it is released?
If compactor
stops during
operation:
*
Is the RESTART light on? Push drawer in while turning key-knob to start. Repeat if necessary.
Rearrange trash
load -
do not load rigid items at front of drawer.
Trash not compacted:
l
Drawer must be at least l/3 full to see compaction.
Not enough
compaction
or force:
l
Compacting
works best when only a few items are loaded. Use the compacting
cycle frequently.
Bottle don't
break:
l
Not all bottles will break every time, depending
upon trash load below it
Drawer won't
open:
.
Drawer will open only when ram is all the way up. To raise the ram, push drawer in firmly; turn key-knob to
START; release key-knob. Open drawer; lay cans and bottles flat in the center of drawer. Start compactor again.
FOR SERVICE OR PARTS INFORMATION,
CALL TOLL FREE TO:
WHIRLPOOL COOL-LINE"
800-253- 1301
Michigan 800-632-2243
Alaska & Hawaii 800-253-l 121
780337
Rev. B
4

Advertisement

loading