Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for GET GPACU12HR
Summary of Contents for GET GPACU12HR
- Page 1 USER INSTRUCTIONS FOR GET PORTABLE 12k BTU AIR CONDITIONER MODEL No. GPACU12HR...
- Page 2 CONTENTS Introduction Safety Notes Identification of parts Installation instructions Operation instructions Maintenance Troubleshooting...
- Page 3 Introduction Thank you for choosing this portable air conditioner to provide you and your family with all of the “Home Comfort” requirements for your home, or office. The appliance can be moved from room to room within your home and set-up in just minutes. It is a multi-functional room air exchanging, air-processing appliance, designed to offer you the functions of: Air Conditioning, Dehumidifying, Heating and Independent Fan.
-
Page 4: Safety Notes
SAFETY NOTES 1. Do not connect to any AC socket outlet that is damaged. 2. Do not use in the following locations:- Next to a source of fire. An area where oil is likely to splash. An area exposed to direct sunlight. An area where water is likely to splash Near a bath, shower or a swimming pool In a greenhouse... -
Page 5: Identification Of Parts
Identification of Parts 1. Control Panel 2. Cold air outlet 3. Remote control receiver window 4. Transport handle 5. Air outlet hose 6. Evaporator air intake 7. Air intake 8. Drain port 9. Mains lead... - Page 6 Installation The air conditioner is supplied with the following accessories Item Description Quantity (No. off) End Fitting A End Fitting B Vent Hose Window / Door Fitting Wall Fitting Wall Fitting Cap Select a suitable location for the unit • The unit should be positioned beside a window or door to allow the vent hose to reach outside the room.
- Page 7 Exhaust Air Ducting This can either be done as a temporary installation through an open door or window, or as a permanent installation through a wall. Temporary Installation 1) Attach one end of the vent hose (item C) to the exhaust air outlet of the air conditioner using an end fitting (item A).
- Page 8 Operation CONTROL PANEL CONTROLS Power Control The power control turns the unit on and off. When the plug is first plugged into a socket the machine will go into stand-by mode. Pressing the “Power” button will turn the machine on. Pressing the “Power” button again will put the machine back into stand-by mode. Warning Light This warning light will illuminate (Red) when the water tank within the machine is full and the machine will stop.
- Page 9 Timer Press the Timer button to set the timer. The green LED next to the ON/OFF legend will flash on and off for 15 seconds. While the green LED is flashing, press the timer/temp adjust buttons (▲▼) to select the time (in hours, between 00 and 24) for either of the timer modes “a”...
- Page 10 REMOTE CONTROL UNIT...
-
Page 11: Trouble Shooting
Trouble Shooting The following cases may not always indicate a fault, please check the unit before contacting the service number. Problem Possible Cause • The protector trip or fuse is broken. • Wait for 3 minutes and start again, protector device may be preventing unit from working. - Page 12 Maintenance Maintenance 1. The air filter should be cleaned periodically. The intervals between cleaning will depend on the amount of airborne dust in the area in which the unit is used. The air filter is removed by sliding it vertically upwards from out of the back of the unit. Wash the filter by immersing it gently in warm water (about 40°C) with a neutral detergent.
- Page 13 Please recycle where facilities exist. Check with your local authority or retailer for recycling advice. GET Plc., Key Point, 3-17, High Street, Potters Bar, Herts. EN^ 5AJ Helpline Telephone No. 0121 565 7770 AR0853 Ed.E...