Safety Feature; Cleaning, Storage And Maintenance; Troubleshooting - Cuisinart ICE-100C Instruction Booklet & Recipe Book

6. Press the Power button to turn the unit on. The red LED light will be on
and the LCD screen will display "00".
7. Press the Timer button to set the time. Once pressed, the timer will
default to 60 minutes. Press and release timer button to decrease time
in 1-minute increments. Press and hold to scroll down more quickly.
Note: Time can be set up to 60 minutes or as low as 10 minutes. If you
added too much time, continue to press Timer and it will bring you
back to ten minutes.
8. Press the Start/Stop button to begin the Mixing/Cooling cycle. Timer
will count down and the blue LED will be on, indicating that the Mixing/
Cooling has begun.
of mixing time. Once the dessert has begun to thicken (about
5 minutes left depending on recipe), add the ingredients through the
mix-in opening.
Note: To turn the unit off at any time, press the Power button. This
will turn the unit off and reset all the previous functions.
9. The timer will count down to zero and when done, the unit will
beep three times to note the ice cream or gelato is ready.
Note: The red LED flash and the timer will be blinking "00".
10. Turn the unit off by pressing the Power button. Remove the lid by
turning it clockwise to unlock. Lift mixing bowl out of the base with
handle. Remove paddle from mixing bowl.
Note: If the unit is not powered off, it will go into the Keep Cool
function. Details follow on this page.
To pause time and mixing:
pause the time and mixing. To restart, press the Start/Stop button again to
continue.
To add time:
If ice cream isn't done or you would like to add time, press the Start/Stop
button to pause unit. Add time in 5-minute increments. Press and hold to
scroll through more quickly. If you added too much time, continue to press
timer and it will bring you back to ten minutes.
Note: When making consecutive batches of ice cream or gelato, be sure to
allow extra time for the compressor to adjust to cooling.
Tip:
before making a second batch.
Keep Cool
This function does exactly what it says....keeps cool! After the Mixing/
Cooling cycle is finished, the unit will go to Keep Cool.
Once your Mixing/Cooling time has finished the timer will blink "00". The
unit is now in the Keep Cool function and has a 10-minute wait period.
After 10 minutes elapse, the compressor will come on and the display will
flash "COOL". The Keep Cool is a 10-minute cycle. When done, the unit will
beep 5 times to note the cycle is finished. The unit will shut off and go into
Standby mode.
Note: The mixing is not activated during the Keep Cool function. If you
would like to mix as well, turn off the unit to reset the functions.
Note: You can turn the unit off at any time during Keep Cool.

SAFETY FEATURE

®
The Cuisinart Commercial Quality Ice Cream & Gelato Maker is equipped
with a safety feature that automatically stops the unit if the motor overheats.
This safety system may activate under heavy loads, if the unit has been
running for an excessively long period of time, or if added ingredients (nuts,
etc.) are added in extremely large pieces.
To reset the unit, press the Power button and unplug the unit. Let the unit
rest. After a few minutes, you may turn the unit on again and continue
making the dessert.

CLEANING, STORAGE AND MAINTENANCE

Cleaning
Clean the mixing bowl, mixing paddles and lid in warm soapy water. Mixing
paddles and lid are top-shelf dishwasher safe. DO NOT PUT MIXING
BOWL IN THE DISHWASHER. DO NOT CLEAN WITH ABRASIVE
CLEANSERS OR IMPLEMENTS. Wipe motor base clean with damp cloth.
Dry all parts thoroughly.
Storage
Be sure to store your unit in an upright position. Do not store frozen
desserts in the mixing bowl in the freezer for more than 30 minutes at a
time. Transfer frozen desserts to a freezer-safe, airtight container for longer
storage in the freezer.
Maintenance
Any other servicing should be performed by an authorized service
representative.
4

TROUBLESHOOTING

PROBLEM SOLUTION
Screen displays "EEEE", Power off and unplug the unit.
continuous beeping and
the unit is stopped.
Contact Customer Service at 1-800-472-7606.
The ice cream could be done. The overload
the time set protection feature will turn the unit off.
If not the reason above, unplug the unit. Let it rest for
2 hours. Power unit on and being making your ice
cream or gelato.
At any time during the Power off and unplug the unit. Let it rest for 2 hours.
mixing/cooling cycle, the Power unit on and being making your ice cream or
unit beeps continuously gelato. If this happens again, let the unit rest for 24
for 30 seconds. hours. If unit continues to beep after you have tried
the above procedure, contact Customer Service at
1-800-472-7606.
Mixing bowl is difficult Wait 2 minutes and lift the mixing bowl.
to lift
Make sure mixing bowl and the base are dry before
making ice cream.
Paddle slippage after Watch for condensation on base of bowl. Clear off
several batches of ice water or ice from mixing bowl and base.
cream
Make sure mixing bowl and base are dry and clean
before making next batch of ice cream.
5