Echo CS-330T Instruction Manual page 9

P
M
L
N
O
NOTE: See "MAINTENANCE AND CARE"
instructions for guide bar, sprocket, and saw chain
maintenance.
5. Mount guide bar (L) on studs, and slide toward
sprocket to make saw chain installation easier. Install
saw chain (M) over clutch and place around sprocket
and guide bar as shown, with cutters on top of guide
bar facing forward.
6. Align holes of clutch cover (K) with guide bar studs,
and tensioner pin (N) with lower guide bar adjuster
hole. Install cover, then press and hold rear of cover
to fully seat. Tighten guide bar nuts finger tight.
7. Turn saw over and check brake band (O) for correct
position around clutch drum (P). If brake band is not
in place around drum, remove clutch cover, make
sure brake is released, and reinstall.
DANGER
Never operate saw if chain brake does not
function properly, otherwise saw damage and
serious personal injury could result. See
"Testing the Brake" instructions.
8. Adjust saw chain tension, as instructed in "Adjust-
ment, Chain Tension"
9