Mold Proof Operation - Daikin E Series Service Manual

Instruction

3.12 MOLD PROOF Operation

MOLD PROOF Operation

Dries the inside of the unit to prevent mold and odors.
Auto operation
(approximately once every 2 weeks)
If the unit is set to "MOLD PROOF ON", the MOLD PROOF operation will start automat-
ically after the unit has been run in "SARARA" DRYING or COOLING mode, depending
on the amount of time the unit has been run (approximately once every 2 weeks).
(page 14.) The default is set to "MOLD PROOF OFF".
Manual operation
1. Hold " " for about 2 seconds while the unit is not
running.
•
The front panel and horizontal louver will open.
•
The MOLD PROOF operation runs for about 3 hours, changing the color of the
multi-colored indicator lamp of the unit.
<Color of multi-colored indicator lamp>
Purple
Blue
Blinks alternately.
If you want to stop MOLD PROOF operation
during operation
2. Hold " " (again) for about 2 seconds.
•
The front panel and horizontal louver will close.
•
The multi-colored indicator of the unit will go off.
NOTE
Note on MOLD PROOF operation
•
Dries out the interior of the air conditioner using FAN and HEATING operation mode to exhaust humidity to the outdoor. This prevents mold
and odor growth. This function is not designed to remove existing dust or mold.
•
During MOLD PROOF operation, the room temperature may rise and humidity from the machine may be sent into the room. Some odors
may be noticed, too.
•
The mode may not be used if the outside temperature or humidity is very high.
•
The exhausting operation may not be run depending on the outdoor temperature.
•
MOLD PROOF operation mode is not available if the unit is shut off using the COUNTDOWN OFF TIMER. MOLD PROOF operation mode
only comes on automatically if the unit has been stopped using the operation/stop switch on the remote controller or the main unit.
•
If MOLD PROOF operation is stopped during AUTO mode, the operation comes on automatically next time, depending on the amount of
time the unit had been operating. To cancel the AUTO mode, set to "MOLD PROOF OFF". (page 14.)
15
120
The MOLD PROOF operation will start.
The display will return to normal.
Blue
Light blue
Blinks alternately. Blinks alternately.
Operation complete
Light blue
White
White
(In case of manual operation)
SiBE04-624
1, 2
System Configuration