Daikin E Series Service Manual page 101

Installation Manual
Indoor Unit Installation
4-4. Wall embedded piping.
Follow the instructions given under
Left-side, left-back, or left-bottom piping
1) Insert the drain hose to this depth so it won't be
pulled out of the drain pipe.
WARNING
Do not bundle the power code with a binding band, a twist tie or other method.
This may cause heat, electric shock or fire.
5.
Humidifying hose installation work.
5-1. Connecting to the indoor unit.
• Connect the cuff side of the humidifying hose to the indoor unit duct.
It is easier to connect the hose
with the front grille removed.
• Left-back piping
Cut the cuff
at this part.
(If it is too long, cut the humidifying hose
and bond the separately sold cuff with
adhesive for vinyl to adjust the length.)
CAUTION
Use caution not to deform the cuff while installing the humidifying hose.
5-2. Connecting the cut humidifying hoses.
• When install the cut humidifying hoses, follow the instructions below.
Insert each humidifying
hose to the rim of the joint
so that there are no gaps.
• Use not more than two elbows to ensure humidifying capacity.
9
90
Cuff
Connect the
cuff side of the
humidifying
hose to the
indoor unit duct.
Humidifying
hose
Apply the binding band
at 10mm from the rim
of the joint to prevent
the humidifying hose
from coming off.
Joint
Insert drain hose
to this depth so
it won't be pulled
.
out of drain pipe.
Insert as far as possible
so that there are no gaps.
The protrusion of the
humidifying hose from the
Approx. 100mm
wall hole is about 100mm.
Apply the binding band at 10mm
from the rim of the elbow to
prevent the humidifying hose
from coming off.
Inner wall
Drain hose
50mm
or more
Vinyl chloride
drain pipe
Outer wall
(VP-30)
Pulling out the
humidifying hose in a
sideward direction.
Pulling out the
humidifying hose in a
downward direction.
Elbow
Insert each humidifying
hose to the rim of the elbow
so that there are no gaps.
System Configuration
SiBE04-624