Snmp Alerts Or Alarm Definitions - IBM SAN04M-R Installation And Service Manual

SNMP alerts or alarm definitions

Table 17
Alert or alarm name
Cold Start
Link Down
Link Up
flashNewImageInstallTrap
envVoltageUpperThreshTrap
envVoltageLowerThreshTrap
envTempUpperTrap
ChasFanStatusTrap
ChasPowerSupplyStatusTrap The status of power changes from down to up or vice versa.
connUnitPortStatus Change
connUnitStatusChange
Figure 11 shows an illustration of the Trap Viewer utility which is
shipped with Sanvergence manager.
Description
The SAN Router is powered on, or rebooted. Informational
only message, no action required.
A GE interface loses an active link signal.
A GE interface acquires an active link signal.
A new firmware image is installed in flash memory.
Informational only message, no action required.
The upper voltage threshold is exceeded. This message
indicates that there may be a problem with the power
supplies or the router.
The power voltage is less than the lower voltage threshold.
This message indicates that there may be a problem with
the power supplies or the router.
The upper temperature threshold is exceeded. This
message indicates that there may be a problem with the
power supplies or the router.
The state of the fan changes. This message indicates there
may be a problem with the power supplies (the fans are part
of the power supply units.)
This message indicates there is a problem with a power
supply.
The overall status of a port that has changed. This
message indicates there may be a problem with a port or a
link is no longer active.
The overall status of the SAN Router that has changed.
Chapter 3: Maintenance and troubleshooting 45