Table of Contents
Advertisement
LENNOX HEARTH PRODUCTS • ELITE LINEAR VIEW DIRECT-VENT GAS FIREPLACE (MODELS LDV42, LDV54) • CARE AND OPERATION INSTRUCTIONS
INSTALLATION/REMOVAL OF
GLASS DOOR ASSEMBLY
WARNING
HOT GLASS WILL CAUSE BURNS.
DO NOT TOUCH GLASS UNTIL COOLED.
• Remove glass door assembly only when
fireplace is OFF and COLD.
• Do not attempt to touch the front enclo-
sure glass with your hands while the
fireplace is in use.
• The glass on the front of the fireplace
reaches EXTREMELY HIGH temperatures
and can cause severe burns if touched.
Even after the gas is turned off, fireplace
surfaces remain extremely hot.
WARNING
Any safety screen or guard removed
for servicing the appliance must
be replaced prior to operating the
appliance.
AVERTISSEMENT
Tout écran ou protecteur retiré pour
permettre l'entretien de l'appareil
doit être remis en place avant de
mettre l'appareil en marche.
WARNING
Do not operate appliance with glass
front removed, cracked or broken.
AVERTISSEMENT
Ne pas utiliser l'appareil si le pan-
neau frontal en verre n'est pas en
place, est craqué ou brisé.
Figure 9
12
Installation of Glass Door Assembly
1. While holding the door assembly by the
side edges, hook the top edge to the fire-
place, and then swing the bottom edge
in toward the fireplace (Figure 9 ), taking
care not to damage the glass.
the door does NOT clear the lower front
frame of the fireplace (and hits the frame
as you swing down the door), make sure
the door's UPPER mounting flange is
completely and properly engaged on the
fireplace frame BEFORE INSERTING THE
SCREWS.
Proper door alignment and sealing are
important to the operation and perfor-
mance of the fireplace. Make sure the
door seal is in contact with the frame and
that no air leaks are present.
2. Align the screw holes below the door
assembly with the holes in the fireplace,
and secure using the (3) provided screws.
Reverse these steps to remove the glass door
assembly.
INSTALLATION/REMOVAL
OF MODESTY PANEL
To install the modesty panel, attach the 3 hooks
to the slots in the door, and then slide it to the
LEFT until fully seated.
To remove the modesty panel, slide it to the
RIGHT and then carefully pull it forward to
release it.
Glass Door Assembly
Rating plate and lighting instructions are
provided on tag attached to door bracket.
NOTE: DIAGRAMS AND ILLUSTRATIONS ARE REPRESENTATIVE AND ARE NOT DRAWN TO SCALE.
IMPORTANT! If the lower flange of
CAUTION
RISK OF PERSONAL INJURY
OR PROPERTY DAMAGE.
• Do NOT abuse glass door by striking or
slamming shut.
• Handle glass with extreme care! Glass is
susceptible to damage; do NOT scratch or
handle roughly while reinstalling the glass
door frame.
• Never operate fireplace with glass door
assembly removed.
These direct-vent appliances are designed
to operate only when glass door assem-
bly is installed. Generally, the glass door
assembly should not be removed, except
when access to components within the
firebox is required.
• Do not attempt to substitute the materials
used on these doors, or replace cracked
or broken glass.
• The glass door(s) of this appliance must
only be replaced as a complete unit as pro-
vided by the manufacturer. Do not attempt
to replace broken, cracked or chipped glass
separately.
Hide quick links:
Advertisement
Table of Contents
