Advertisement
Slide washer/dryer onto cardboard or
hardboard before moving across floor to
prevent damage to floor covering.
7.
Place a piece
of cardboard or
hardboard in front of
carton. Now stand the
washer/dryer upright.
Slide washer/dryer
onto cardboard or
hardboard.
To prevent
product
damage, do
not remove
corner posts
before cutting.
8.
With the corner posts in place,
cut the carton down one corner.
Remove carton.
Do Not
remove.
9.
Remove
the two rear corner
posts located at the
back of the washer/
dryer. Remove the two
corner pieces attached
to the lower front of the
washer/dryer. Do Not
remove the foam
shipping pieces
lower
between the washer
front
and dryer until the
corner
posts
washer/dryer is in place.
10.
Move foam
shipping pieces outward just enough to clear
the washer lid. Open the washer lid. The
latch under the dryer will hold lid open.
4.
5.
4.
5.
7.
Panel C
11. 29.
rear
corner
posts
11.
front and the back. Lift to remove from inside
washer.
latch
12.
hoses with other parts.
8.
6.
6.
Numbers
correspond
to steps.
9.
round
shipping
piece
Grasp round shipping piece at the
Take hoses out of basket. Place
Numbers
correspond
to steps.
35.
13.
10.
11.
12.
9.
13.
Release washer
lid by pushing up on latch.
Close lid.
Use new hoses and washers that came
with your washer/dryer.
14.
coupling washer
Insert a flat washer into each end
of the inlet hoses. Check that washers are
firmly seated in couplings.
cold
Inlet valves are
plastic. Do Not
strip or
crossthread.
hot
15.
Attach hose to bottom
inlet valve opening first. Attach second hose
to top inlet valve. Tighten couplings by hand;
then use pliers to make an additional two-
thirds turn.
IMPORTANT: THIS PROCEDURE MUST BE
FOLLOWED TO ASSURE PROPER
INSTALLATION.
clamp
drain
drain
hose
connector
16.
To prevent the drain hose from
coming off or leaking, it must be installed per
the following instructions:
1. Wet the inside end of the drain hose with
tap water. DO NOT USE ANY OTHER
LUBRICANT.
2. Squeeze ears of small clamp with pliers to
open clamp and place clamp over end
of drain hose.
3. While holding clamp open, work end of
drain hose onto drain connector until
drain hose is within 0.64 cm (1/4 in) of
ribbed stop.
4. Position clamp over the drain hose area
marked "clamp." Release clamp. Clamp
should be 0.64 cm (1/4 in) from end of
drain hose.
9.
latch
0.64cm
(1/4")
max.
0.64cm
(1/4")
max.
Advertisement
