Bluetooth hands-free kit retrofit for bmw x5 (e53) 2001; bmw x5 (e53) 2002; bmw x5 (e53) 2003; bmw x5 (e53) 2004; bmw x5 (e53) 2005; bmw x5 (e53) 2006; bmw x5 (e53) 2007; bmw x5 (e53) 2008; bmw x5 (e53) 2009; bmw x5 (e53) 2010; bmw x5 (e53) 2011; bmw x5 ( (19 pages)
Retrofit bmw accessory menu acm for bmw 1 series (e81, e82, e87) bmw 3 series (e90, e91, e92, e93) bmw 5 series (e60, e61) bmw 6 series (e63, e64) bmw x5 (e70) bmw x6 (e71) (42 pages)
Siemens hands-free facility retrofit kit with speech input for bmw 3 series saloon (e36/4) lhd, bmw 3 series coupe (e36/2) lhd, bmw 3 series touring (e36/3) lhd, bmw 3 series convertible (e36/c) lhd, bmw 3 series compact (e36/5) lhd (21 pages)
Product Introduction Congratulations on the purchase of a new AccessPORT hand-held programmer. This quick start guide explains how to install the AP on your vehicle. Refer to the AP user manual located online at http://cobbtuning.com/bmw. Check the website for more information about features, capabilities and additional instructions.
For installation purposes, it is important to ensure that the vehicle’s battery has adequate power for both the AccessPORT and the ECU. Because of this, it is recommended that all in-car electronics and vehicle lights are turned off during the installation process to reduce drain on the vehicle’s battery.
Page 4
3. Plug the male OBDII plug from the AccessPORT into the uncovered OBDII port. 4. Connect the small end of the OBD-II cable to the 10 pin port on the bottom of the AccessPORT. 5. Make sure the clasp on the OBD-II cable firmly engages the tab on the 10 pin port.
Page 5
ON position. 7. Select Install to proceed with installation. WARNING! Do not disturb the AccessPORT or OBD-II cable while installation is taking place. Failure to do so may result in incomplete ECU reprogramming which will render the vehicle inoperable. Vehicle Identification: The AccessPORT will attempt to automatically determine the target vehicle for installation.
Live Data monitoring and Data Logging features. Please note that the AccessPORT is designed to work with only one vehicle at a time. Once the AccessPORT is installed, it cannot be used with another vehicle until it is uninstalled from the original vehicle.
Page 7
AccessPORT did not come pre-installed with a map that is appropriate for the target vehicle. To load a new or updated map to the AccessPORT, simply download and save the map file to an easy-to-remember location (My Documents, Desktop, etc.). After the map file is completely downloaded, double-click the map file to automatically run the AP Manager software and import it to the map library.