Installing The Software; Windows Xp - Vox JamVOX Installation & Setup Manual

Installing the software

Windows XP

To install the software in Windows XP, proceed as follows.
Don't connect the JamVOX Monitor to your computer until you've
installed the JamVOX Driver and Software.
1
Insert the installation CD into your CD drive. The installer will start up.
2
Click [Install], and proceed as directed by the on-screen instructions.
Note Sibelius Scorch is the web browser plug-in to view the scores from GuitarIn-
structor.com. If you want to install this plug-in, click and select the Sibelius
Scorch installer. In certain cases, it may take some time for the Sibelius Scorch
installer to start up. If so, please wait until the installation screen appears.
3
When the installation is finished, click the [Close] button to exit the installer.
4
A screen will tell you to connect the JamVOX Monitor to your computer. Click
the [OK] button, and use the USB cable to connect the JamVOX Monitor to
your computer. In the lower right of the Windows screen, there will be a mes-
sage saying "Your new hardware is installed and ready to use."
Note When "Found New Hardware Wizard" appears, install the driver as directed
by the on-screen instructions.
When "A problem occurred during hardware installation." appears in the
lower right of the Windows screen, reconnect the JamVOX Monitor.
5
Double-click "JamVOX" on the desktop.
6
Click [Install], and install the JamVOX USB Driver as directed by the on-screen
instructions.
7
When the installation is finished, click the [OK] button to exit the installer.
Note On a Windows computer, you'll need to perform the step from 4 to 7 again if
you connect the JamVOX Monitor to a different USB port.
7