Air Source - Central Pneumatic 32046 Set Up And Operating Instructions Manual

b. do not force the tool.
correct tool for the application. The
correct Air Angle Die Grinder will do
the job better and safer at the rate for
which the tool is designed.
c. do not use the tool if the switch
does not turn the tool on or off.
Any tool that cannot be controlled
with the switch is dangerous and
must be repaired.
d. disconnect the tool from the air
source before making any adjust-
ments, changing accessories, or
storing the tool. Such preventive
safety measures reduce the risk of
starting the Air Angle Die Grinder
unintentionally. Turn off and detach
the air supply, safely discharge any
residual air pressure, and release the
throttle and/or turn the switch to its off
position before leaving the work area.
e. Store the Air Angle Die Grinder
when it is idle out of reach of chil-
dren and other untrained persons.
A die grinder is dangerous in the
hands of untrained users.
f. maintain the tool with care.
properly maintained tool is easier to
control.
g. check for misalignment or bind-
ing of moving parts, breakage of
parts, and any other condition
that affects the tool's operation.
If damaged, have the Air Angle Die
Grinder serviced before using. Many
accidents are caused by poorly main-
tained tools. There is a risk of burst-
ing if the tool is damaged.
h. use only accessories that are
identified by the manufacturer for
the specific tool model. Use of an
SKU 32046
Use the
A
For technical questions, please call 1-800-444-3353.
accessory not intended for use with
the specific tool model, increases the
risk of injury to persons.
Service
a. Tool service must be performed
only by qualified repair personnel.
When servicing the air angle die
b.
grinder, use only identical replace-
ment parts. use only authorized
parts.
c. use only the lubricants supplied
with the tool or specified by the
manufacturer.

air source

a. never connect to an air
source that is capable of
exceeding 200 psi. Over
pressurizing the tool may
cause bursting, abnormal operation,
breakage of the tool or serious injury
to persons. Use only clean, dry,
regulated compressed air at the rated
pressure or within the rated pressure
range as marked on the tool. Always
verify prior to using the tool that the
air source has been adjusted to the
rated air pressure or within the rated
air-pressure range.
b. Never use oxygen, carbon dioxide,
combustible gases or any bottled
gas as an air source for the tool.
Such gases are capable of explosion
and serious injury to persons.
SaVe theSe
inStructiOnS.
Page 4