Advertisement
Revo Burst™
System Menu: When making adjustments you can press
ENTER to confirm your setup or you can wait 8 seconds for
automatic setup. To exit without making any adjustments
press the MENU button.
ADDR -
DMX Address Setting.
1. Tap the either the MENU, UP, or DOWN buttons until "ADDR"
is displayed, press ENTER.
2. The current address will now be displayed and flashing. Press
the UP or DOWN buttons to find your desired address. Press
ENTER to set your desired DMX address.
CHND -
This will let you switch between 4 Channel DMX
mode and 10 Channel DMX mode.
1. Tap the either the MENU button until "CHND" is displayed,
press ENTER. Either "4CH" or "10CH" will be displayed
2. Tap the UP or DOWN buttons to choose your desired DMX
mode and press ENTER to confim and exit.
SLND -
This will let you set unit as a master or slave in a
master/slave configuration.
1. Tap the MENU button until "SLND" is displayed, press ENTER.
Either "MAST", "SL 1" or "SL 2" will be displayed.
2. Tap the UP or DOWN buttons until your desired setting is
displayed, press ENTER to confim.
NoTE: In a Master/Slave configuration you can set one fixture
to Master and then set the next fixture to "SL 2", the fixtures will
now have contrast movement to each other.
American DJ Supply
- www.americandj.com - Revo Burst™ User Manual Page 8
©
®
System Menu
Revo Burst™
on pages 5-7 as well as the set-up specifications that are includ-
ed with your DMX controller.
3. Use the controller's faders to control the various DMX fixture traits.
4. This will allow you to create your own programs.
5. Follow the instructions on page 9 to set the DMX address.
6. For longer cable runs (more than a 100 feet) use a terminator on
the last fixture.
7. For help operating in DMX mode consult the manual included
with your DMX controller.
Sound Active Mode:
units linked together, to run to the beat of the music.
1. Tap the MENU button until
ENTER.
2.
Tap the UP or DOWN buttons to choose either OFF or ON, and
press ENTER, then press and hold MENU for 3 seconds to con-
firm.
3. The optional UC3 Controller (not included) may be used to con-
trol different functions including blackout.
Show Mode:
run.
1. Tap the MENU button until
ENTER.
2.
Tap the UP or DOWN buttons until you find your desired show,
and press ENTER then press and hold MENU for 3 seconds to
con firm. See page 9 for more info.
3. The optional UC3 Controller (not included) may be used to con-
trol different functions including blackout.
Revo Burst™
With this feature you can connect the fixtures to one another
using the IEC input and output sockets. The quantity that can be
connected is 16 fixtures maximum. After 16 fixtures you will need
to use a new power outlet. They must be the same fixtures. Do
NoT mix fixtures.
©
This mode allows either single unit or several
"SOUN" is displayed, and press
In this mode you can choose 1 of 12 show modes to
"SHND" is displayed, and press
American DJ Supply
- www.americandj.com - Revo Burst™ User Manual Page 13
®
Operating Instructions
Power Cord Daisy Chaining
Advertisement
