Warnings - Graco 16N661 Operation - Repair - Parts

Warnings

Warnings
The following warnings are for the setup, use, maintenance, and repair of this equipment. The exclamation point sym-
bol alerts you to a general warning and the hazard symbols refer to procedure-specific risks. When these symbols
appear in the body of this manual or on warning labels, refer back to these Warnings. Product-specific hazard sym-
bols and warnings not covered in this section may appear throughout the body of this manual where applicable.
GROUNDING
This product must be grounded. In the event of an electrical short circuit, grounding reduces the risk of electric
shock by providing an escape wire for the electric current. This product is equipped with a cord having a grounding
wire with an appropriate grounding plug. The plug must be plugged into an outlet that is properly installed and
grounded in accordance with all local codes and ordinances.
• Improper installation of the grounding plug is able to result in a risk of electric shock.
• When repair or replacement of the cord or plug is required, do not connect the grounding wire to either power
terminal.
• The wire with insulation having an outer surface that is green with or without yellow stripes is the grounding
wire.
• Check with a qualified electrician or serviceman when the grounding instructions are not completely
understood, or when in doubt as to whether the product is properly grounded.
• Do not modify the plug provided; if it does not fit the outlet, have the proper outlet installed by a qualified
electrician.
• This product is for use on a nominal 230 V circuit and has a grounding plug similar to the plug illustrated in the
figure below.
• Only connect the product to an outlet having the same configuration as the plug.
• Do not use an adapter with this product.
Extension Cords:
• Use only a 3-wire extension cord that has a grounding plug and a grounded receptacle that accepts the plug on
the product.
• Make sure your extension cord is not damaged. When using an extension cord, be sure to use a cord large
enough to carry the current that your sprayer draws. See chart for appropriate sizes and lengths.
Extension Cord Conductor
• An undersized extension cord will result in a drop in line voltage and loss of power, overheating, and possible
damage to equipment.
3A2854A
WARNING
WARNING WARNING WARNING
Extension Cord Length
Size (Minimum)
2
1.0 mm
2
1.5 mm
4
2.5 mm
(Maximum)
15 m (50 ft)
30 m (100 ft)
50 m (164 ft)
3