Toyostove Laser 56 Installation And Operation Instructions Manual page 27

6. Insert the bent joint to the exhaust mouth of the flue pipe. Cut the inlet hose for desired length if
necessary. Attach the L-shaped hose to each end of the inlet hose and attach the L-shaped hose to the in
take mouth of the flue pipe. Secure the L-shaped hose to the intake mouth with the hose band. Plug the
unused exhaust and intake mouth with the caps provided with the heater. Make sure the caps fit tightly
onto the mouth (See Fig. 10).
NOTE: If the inlet hose is not smoothly inserted into the L-shaped hose, apply water or soap suds to
the inlet hose.
7. In case the circuit board cover gets in the way of the connection of the standard flue pipe, use the
extension pipe (S) for the exhaust outlet mouth of the heater (See Fig. 11).
Fig. 10
Fig. 11
27