Advertisement
Upon entering the program, a table is displayed to show all 64 units each units
switch status. After a switch command is sent and an O.K. message is received, the
table will be updated. The status will be saved upon exiting the program, and read
when opening the program.
Connect
Click on the Connect menu on the toolbar. Select the desired connection - LAN,
Comport, or Modem and enter the appropriate information as requested.
Enter the desired Unit # and the Switch # by clicking on the appropriate drop down
boxes or by clicking on the corresponding grid in the table.
Enter the desired switch command:
Clicking on PRI – Sends the Primary (Basic) signal input to output.
Clicking on SEC – Send the Secondary (Premium) signal input to output.
Clicking on OFF – Disconnects the output from either input.
Click on Send Command to send the switching commands to the MDS636. If the
commands are received the unit will reply O.K. and the switch table will record the
entries. This information will also be saved to the MDS636.cfg file with a default
password Monroe-636.
Set-up and Operation
9
Advertisement
