Programming; Programming Pads - Amana ACE530 Service

Programming Pads

Oven is shipped from the factory for single pad programming. To change
the oven default to double pad programming, see User Option section. To
program the amount of time, power level, or temperature setting for a pad:
1. Oven must be ON.
• Press PREHEAT ON/OFF.
• ITEM must flash in display.
2. Press PROGRAM SAVE.
• Programming mode begins.
PROG
• displays.
• Oven is in programming mode.
3. Press pad to be programmed or reprogrammed.
• Display will change to review all settings for the pad.
• The pad number that is being programmed displays
below the word ITEM.
4. Press TIME to program amount of cooking time.
• Enter desired cooking time by using numeric key pads.
5. Press TEMP pad to program the cooking temperature.
• Enter desired convection temperature by using
numeric pads.
6. Press POWER LEVEL to program level of microwave
power.
• Press POWER LEVEL again to set to H (High).
• For a lower microwave power, press pads 1 (for 10%)
through 9 (for 90%). 0 turns off the microwave
power and cooking is by convection only.
7. Press PROGRAM SAVE to save the program changes.
8. To discard changes, press STOP/RESET.
Programming Multiple Stages
Stage cooking allows consecutive cooking cycles without interruption.
Up to four different cooking cycles can be programmed into a memory pad.
To use stage cooking:
1. Follow steps 1 through 6 above.
7. Press STAGE.
• This will begin programming for the next cooking
stage.
• Display indicates stage to be programmed.
• Enter cook time, temp and power level as in steps 4. 5 and 6.
• To enter another cooking stage for that pad, press STAGE pad
again.
• Up to four different stages can be programmed.
8. Press PROGRAM SAVE to save the program and
changes.
9. To discard changes, press STOP/RESET before
pressing PROGRAM SAVE.
RS5320016 Rev. 0

Programming

Preheat Setting
The convection temperature setting
can be set between 65°C to 250°C
(150°F to 475°F). It is recommended
PREHEAT
to set the preheat setting to the most
ON / OFF
commonly used temperature for that
oven. The factory default preheat
setting is 230°C (450°F).
PROGRAM
To program the preheat setting:
SAVE
1. Press PROGRAM SAVE pad.
2. Press TEMP pad.
3. Enter desired temperature by
TIME
4. Preheat temperature is
TEMP
POWER
LEVEL
PROGRAM
SAVE
STAGE
several different cooking cycles, or
stages, to be used consecutively
without repeated input from the user.
Stage cooking can be set to to
defrost food initially, then cook it, and
then keep the food warm until
serving time.
Example of Stage Cooking Conditions
Temp
STAGE
Power
Time
PROGRAM
SAVE
A–10
Programming
using the numeric key pads.
changed.
What is stage
cooking?
Stage cooking enables
Stage 1 Stage 2
230°C 230°C
H (high) 3
2:30 1:30
Stage 3
230°C
0
1:30