Toshiba Satellite P205D Maintenance Manual page 167

4.11 Display Assembly
Installing the Display Assembly
To install the display assembly, follow the steps below and refer to the figures in the
preceding section.
1. Seat the display assembly, taking care not to crush to the LVDS cable (JP4) or wireless
LAN antenna connectors.
2. Secure two M2.5x8 black screws to each hinge to connect the assembly on the top cover.
3. Secure two M2.5x8 black screws to the computer's rear side. They hold the display
assembly in place.
4. Replace the strip cover.
5. Connect the LVDS cable (JP4), function button board cable (JP15), wireless LAN
antennas, CMOS cable, and microphone cable (JP16) to their respective sockets on the
system board.
Satellite P200D/P205D Series Maintenance Manual
[CONFIDENTIAL]
4 Replacement Procedures
4-33