Displaying Traffic/Security Filters - ProCurve 2900 Manual

Displaying Traffic/Security Filters

This command displays a listing of all filters by index number and also enables
you to use the index number to display the details of individual filters.
Syntax: show filter
Lists the filters configured in the switch, with
corresponding filter index (IDX) numbers.
IDX:
identify the filter for a detailed information listing. A
filter retains its assigned IDX number for as long as the
filter exists in the switch. The switch assigns the lowest
available IDX number to a new filter. This can result in
a newer filter having a lower IDX number than an older
filter if a previous filter deletion created a gap in the filter
listing.
Filter Type:
number (source-port, multicast, or protocol).
Value:
source port or trunk assigned to the filter
[ index ]
Lists the filter type and other data for the filter corre­
sponding to the index number in the show filter output. Also
lists, for each outbound destination port in the switch, the
port number, port type, and filter action (forward or drop).
The switch assigns the lowest available index number to a
new filter. If you delete a filter, the index number for that
filter becomes available for the next filter you create.
For example, to display the filters created in figure 8-16 on page 8-22 and then
list the details of the multicast filter for multicast address 010000-224466:
An automatically assigned index number used to
Indicates the type of filter assigned to the IDX
Indicates the port number or port-trunk name of the
Traffic/Security Filters and Monitors
Configuring Traffic/Security Filters
8-23