Dometic RM7030 Service Manual page 29

DOMETIC® RM7030/RM7732
Refrigerators
RM7732:
SECURING THE REFRIGERATOR:
After the refrigerator is mounted in place (ensuring a
combustion seal at the front frame), the refrigerator is to
be secured in the enclosure with six screws. The screws
have to be installed in the following order:
STEP 1: Two screws installed through the front
base, which includes the lower front strip installa-
tion.
The refrigerator is provided with a lower front strip
(shipped as a loose part). The front strip is to be
attached after the refrigerator is set into the cutout
opening.
A. Install the lower front strip by maneuvering it under
the bottom hinge plates, as shown in FIG. 7.
FIG. 7
B. Secure the refrigerator and the lower front strip with
two screws: One screw through each hinge. See
FIG. 8.
FIG. 8
STEP 2: Install the two screws in the top frame.
A. The top decoration panel must be removed from
the refrigerator before the screws can be in-
stalled. Open refrigerator door and gently push
the tabs out of the hole in the hinge with flat blade
screwdriver. See FIG. 9.
26
DIAGNOSTIC SERVICE MANUAL
B. Carefully tilt the top decoration panel and lift up to
remove from top frame. See FIG. 9.
FIG. 9
C. Install the second two screws in the top frame as
shown in FIG. 10.
FIG. 10
STEP 3: Two screws installed in the rear base.
See FIG. 11
FIG. 11
Failure to follow the sequence in securing refrigera-
tor in the enclosure can cause leakage between the
frame and cabinet.
USE SCREWDRIVER
TO PUSH TABS OUT
OF HOLE
Screws