Storing The Appliance; Changing The Plug - Salton Elite SB900E Instructions And Warranty Information


Always remember to unplug the unit from the electrical outlet when not in use
and before cleaning. Ensure that the speed control is set to "0".

It is much easier to clean the blender directly after it has been used. Place
lukewarm water into the glass jug and turn the switch to 'M' briefly several times.
Empty the glass jug, disassemble it and wash the parts in warm, soapy water,
rinse and dry well.

Take extra care when handling the blades, as they are very sharp.

The motor block should be cleaned with a damp cloth only. Do not let water enter
the motor block.

All parts except the motor block are dishwasher suitable.

Do not use bleach or other abrasive substances or solvents to clean your
appliance as it can damage the finish.

Do not immerse the motor block in water or any other liquid, or hold it under a
running tap to clean.

To remove stubborn spots/marks, wipe the surfaces with a cloth slightly
dampened in soapy water or mild non-abrasive cleaner. Rinse and dry a clean,
dry, soft cloth.

STORING THE APPLIANCE


Unplug the unit from the wall outlet and clean all the parts as instructed above.
Ensure that all parts are dry before storing.

Store the appliance in its box or in a clean, dry place.

Never store the appliance while it is still wet or dirty.

Never wrap the power cord around the appliance. There is a cord storage facility
in the base of the motor block.

CHANGING THE PLUG

The unit is supplied with a 2 pin VDE plug.
If you wish to change the plug to a 3 pin, round pin plug, please connect as follows:
The wires in this mains lead are coloured in accordance with the following code:
Green/Yellow = Earth Blue = Neutral
6
Brown = Live