Technical safety devices ..........................4 1.2.1 Thermostat ..............................4 Technical description ........................... 5 1.3.1 Dimensions EES 30 en EES 40 ........................5 1.3.2 Dimensions EES 52, EES 66, EES 80 en EES120 ..................6 FOR THE INSTALLER ..........................7 Installation instructions ..........................7 2.1.1...
1. GENERAL Description of the apparatus The construction and equipment of the electric storage heater meet the European standards for electric household apparatus (IEC 335-1 and IEC 335-2-63 / EN60335-2-21). Thus, the heater is in conformity with the European directives of electric household apparatus, implying the authority to bear the CE-mark.
Technical description IMD -0299 EES 30, ...120 1.3.1 Dimensions EES 30 en EES 40 TYPE EES 30 EES 40 Total height 1110 Diameter of the apparatus Height of drain tap Height of T&P plug Connection cold water ¾” -14 NPT ¾” -14 NPT Connection hot water ¾”...
IMD -0299 EES 30, ...120 1.3.2 Dimensions EES 52, EES 66, EES 80 en EES120 TYPE EES 52 EES 66 EES 80 EES 120 Total height 1370 1530 1540 1620 Diameter of the apparatus Height of drain tap Height of T&P plug...
2. FOR THE INSTALLER Installation instructions 2.1.3 Electrical connection The electric installation will always be effected by an The heater will not be installed but in spaces meeting the authorised installer, as well as according to the general national and local regulations. These spaces will be frost and current regulations of the electricity works.
Putting into operation 2.2.4 Temperature control The apparatus is under the pressure of the water supply (max. 8 bar). There will be supplied the same quantity of 2.2.1 Filling of the heater cold water as the one used up of hot water. This implies 1.
Safety thermostat Every heater has got a number of safety thermostats interrupting the elcetric circuit, at high water temperatures (95°C). These safety thermostats cannot be reset but after a drecrease of the temperature by 20°C. Subsequently, the regulating thermostat will be checked: if it has been adjusted at a high temperature, the thermostat will probably be broken and must be replaced.
3. FOR THE USER Instructions for use Putting out of operation 3.1.1 Advice Operating procedure: I. For short periods: Remove the plug from the socket Installing and putting into operation the heater for the first or, with a fix connection, turn off the main switch. time will have to be done by an authorised installer. 2. For longer periods it will be recommendable, in view of the danger of frost, not only take the measures 3.1.2 Filling of the heater indicated sub 1, but also turn off the water supply pipe...
Measures in case of failure Trouble Cause Measures to be taken Insufficient or no hot water at all The temperature is set too low Adjust the regulating thermostat higher The safety thermostat is interrupting Press the reset button the electric circuit There is no hot water supply left Reduce the hot water consumption.
6°DH; Tank warranty f) if unfiltered, recirculated water flows through or is If (an EES 30 to 120), within 5 years of the original stored in the boiler installation date, after investigation and exclusive g) if the owner has attempted to repair a defective boiler evaluation by A.O.