Drawer Assembly; Drawer Rails; Front Roller Assembly; Rear Roller Assembly - Amana 19 Service Manual

Disassembly Procedures
To avoid risk of electrical shock, personal injury, or death, disconnect electrical power source to unit, unless test
procedures require power to be connected. Discharge capacitor through a resistor before attempting to service.
Ensure all ground wires are connected before certifying unit as repaired and/or operational.
SCORE CAPILARY TUBE
Drawer Assembly (some models)
1. Open drawer to fully open position.
2. Remove upper basket.
3. Remove screws one in each rail marked on side of
rail.
4. Lift front of drawer up and out to remove drawer.

Drawer Rails

1. Remove screws inside plastic rail retainer.
2. Remove rails from retainer by depressing plastic tabs
on back side of retainer.
3. Slide rails off of retainer.
Bottom of Cabinet

Front Roller Assembly

1. Remove toe grille by pulling it straight away from unit.
2. Raise front of refrigerator at least 4" off the deck and
block it up.
3. Unscrew leveling bolt until wheel is free of leveling
bolt.
4. Tip wheel assembly down until wheel assembly will
slide out of mount from the rear of assembly.
5. Remove roller assembly from unit.

Rear Roller Assembly

NOTE: Condensate drip pan may spill when steps 1
thru 4 are performed. Have a towel ready to
mop up spillage.
1. Tape both doors shut to prevent doors from opening
2. Raise back of refrigerator at least 4" off the deck and
block it up.
3. Remove machine-compartment cover.
4. Locate and slide roller pins out of rollers.
5. Install new rollers and reinstall pins.
16021484 Rev. 1
!
WARNING
UNBRAZE COPPER
SUCTION FITTING
34

Machine Compartment

Condenser Fan & Fan Motor
1. Remove machine compartment cover.
2. Unplug wiring harness connector from fan motor.
3. On backside of fan motor, screws secure the motor to
its brackets. Remove those screws.
4. Note which side of fan blade is “front” and which side
is “rear.” Then use pliers to loosen nut that secures
fan blade to motor shaft. Remove nut and fan blade.
CO ND EN S ER F AN
HAR N ES S P LU G

Compressor

NOTE: Install new drier and compressor per
instructions in “Service Procedures.” Evacuate
and recharge sealed system per instructions in
“Service Procedures.”
1. Remove machine compartment cover.
2. Remove drier.
3. Disconnect all compressor wiring and overload/relay
assembly.
4. Unbraze low and high pressure lines at compressor.
5. Remove compressor mounting bolts.
6. Lift compressor out of unit.

Overload/Relay/Capacitor

1. Remove machine compartment cover.
2. Using fingers and standard screwdriver, press and
pry bale strap off the overload/relay assembly
3. Disconnect wires from overload/relay assembly.
Reference wire location.
4. Unplug overload/relay assembly from compressor.
M A C HINE CO M P ART M EN T
C O V ER
W AT E R VA LV E
CO V ER