Flymo Power Trim Instruction Manual page 6

To replace nylon line
For your convenience it is recommended you buy spool
and line complete. Nylon line only is also available. Both
are available from Husqvarna UK Ltd. stockists.
To fit spool and line complete:
1. Remove the cap.
2. Remove old spool.
3. Place new spool into spoolholder with cut out areas of
the spool in line with eyelets as shown in figure P.
4. Release one line from cleat and feed line through eyelet (P).
5. Repeat for second line.
• Ensure spool is fully located by gently rotating it dur-
ing fitment, whilst keeping the spoolholder steady.
7. Refit the cap.
To fit nylon line only:
• Remember ! Your Trimmer is designed to use only
nylon line with a maximum diameter of 1.5mm. Use
only genuine Husqvarna UK Ltd. nylon line.
1. IMPORTANT - Always wind the line onto the upper
section of the spool first.
Take approximately 5 metres of line. Insert 15mm of
line into one of the holes in the upper section of the
spool (Q) and wind line in the direction of the arrows
on the top of the spool. Leave approximately 100mm
of line unwound and place into cleat as illustrated in
figure Q1. Repeat on lower section of spool.
2. Care should be taken to ensure that the line is neatly
coiled on the spool. Failure to do so will impair the effi-
ciency of the automatic line feed.
3. Then fit spool as described in 'To fit spool and line
complete', section above.
WARNING Disconnect from the mains electricity supply before attempting any maintenance or adjustment.
FAULT
LINE NOT FEEDING
OR
LINE TOO SHORT
OR
TRIMMER VIBRATES
CONTINUOUS
CLATTERING NOISE
LINE SNAPS CONTINUOUSLY
IF NONE OF THE ABOVE
OR IF FAULT PERSISTS
Cutting Head Cont'
Fault Finding Chart (Automatic Line Feed only)
Is the automatic line feed work-
ing?
Is the line fed out and visible?
Has line been removed from
cleat?
Is the manual line feed working?
Has the motor reached full
speed before use?
Has too much line been fed out?
Is the line cutter missing from the
safety guard?
Are you using the trimmer cor-
rectly?
Is the line jamming on the spool?
Contact Husqvarna UK Ltd. Customer Service
Telephone : 01325 300303
P
Q
CHECK
Cut out area
of spool
Q1
ACTION
No
Manually feed out line.
Remove cap and spool, free line
No
and re-fit spool and cap.
The line may be jammed on the
No
spool. Rewind line to remove
crossed loops. Check that line is in
correct section of spool.
Allow the motor to reach full speed
No
before use
Yes
Rewind line.
Contact your local approved Service
Yes
Centre or Husqvarna UK Ltd. Cus-
tomer Service.
?
Only use tip of nylon line to trim.
Rewind the line on the spool, if
Yes
symptoms still persist, change
spool and line.
Eyelet
Cleat