Table of Contents
Advertisement
Test Mode
Test Mode Operating Features
This transceiver has a test mode. To enter test mode,
press [SCN] key and turn power on. Hold [SCN] key until
test channel No. and test signalling No. appears on LCD.
Test mode can be inhibited by programming. To exit test
mode, switch the power on again. The following functions
are available in test mode.
Controls
[PTT]
Used when making a transmission.
[MON]
Monitor on and off.
[SCN]
Sets to the tuning mode.
[A]
Function on.
[D/A]
RF power high and low.
[ ]
Changes signalling.
[ ]
Changes wide and narrow
[CH
/
]
Changes channel.
[Volume
/
]
Volume up/down.
LCD indicator
"SCN"
Unused.
"AUX"
Lights at RF power low.
"MON"
Lights at monitor on.
"Right side dot" Lights at narrow.
LED indicator
Red LED
Lights during transmission.
Green LED
Lights when there is a carrier.
Frequency and Signalling
The set has been adjusted for the frequencies shown in
the following table. When required, re-adjust them following
the adjustment procedure to obtain the frequencies you want
in actual operation.
Frequency (MHz)
Channel No.
RX
1
370.050
2
350.050
3
389.950
4
370.000
5
370.200
6
370.400
7~16
-
ADJUSTMENT /
C6
TX
370.100
350.100
389.900
370.000
370.200
370.400
-
TK-868G
19
Hide quick links:
Advertisement
Table of Contents
