Ryobi RED1520G Operator's Manual page 4

Use this edger for edging along sidewalks, driveways,

and flower beds. Do not use for any other purpose.
Do not use the edger on or near graveled surfaces.

If the edger strikes any type of foreign object:

a) Stop the edger and disconnect from the power
supply.
b) Inspect for any damage to the edger attachment.
c) Correct any damage before using the edger
attachment. Failure to do so can cause serious
injury.
Make yourself familiar with the area you are edging.

Be aware of uneven sidewalks and holes in the
terrain as well as other similar hazardous conditions
(example: wire or wire rope which can break off and
become a dangerous projectile).
Always push the edger attachment slowly over rough

ground.
Never direct discharge of material toward bystanders

or allow anyone near the area of operation. Use care
in directing discharge to avoid grass enclosures,
automobiles, etc.
Always stop the motor and disconnect from power

supply before attempting to remove any obstruction
caught or jammed in the blade, installing attachment,
or making any adjustments.
To reduce the risk of fire, do not allow excessive

grass, leaves, or grease to accumulate on the
Some of the following symbols may be used on this product. Please study them and learn their meaning. Proper
interpretation of these symbols will allow you to operate the product better and safer.
SYMBOL NAME
V Volts
A Amperes
Hz Hertz
W Watt
min Revolutions or reciprocations per minute
Alternating Current
Direct Current
Class II construction
Wet Conditions Alert
Electric Shock Precaution
ENGLISH
product. Do not attempt to remove cut material nor
hold material to be cut when the motor is running or
when the cutting blade is moving.
Always keep your right hand on the rear handle and

your left hand on the front handle when the blade is
rotating.
Always beware of the power cord location and keep

clear of the area you are working in. Cords may
become a trip hazard to the operator. Cords that are
in the cutting path may be cut by the edger.
Never stand or have any part of your body in line with

the path of the edger blade.
A coasting blade can cause injury while it continues

to spin after the motor is stopped or throttle trigger
released. Maintain proper control until the blade has
completely stopped rotating.
Do not leave product unattended.

If the power supply cord is damaged, it must be

replaced only by the manufacturer or by an
authorized service center.
Save these instructions. Refer to them frequently

and use them to instruct others who may use this
tool. If you loan someone this tool, loan them these
instructions also to prevent misuse of the product and
possible injury.
SYMBOLS
DESIGNATION/EXPLANATION
Voltage
Current
Frequency ( cycles per second )
Power
Speed
Type of current
Type or a characteristic of Current
Double-insulated construction
Do not expose to rain or use in damp location.
Remove plug from the mains immediately if cable is
damaged or cut.
3