Comfort Glow CGFB32CA Installation Manual page 9

INSTALLATION
Continued
conventional Installation of blower
Accessory
1. Install blower assembly per instruction sheet
included in blower accessory kit.
2. Before replacing bottom of firebox, route
blower power cord through hole in support
bracket in bottom of firebox and through hole
in side of firebox to grounded, three-prong
120 volt electrical outlet (see Figure 8). Plug
electrical cord into outlet.
3. Replace bottom of firebox.
notiCe: a certified electrician
must connect electrical wiring to
duplex outlet for built-in instal-
lation. follow all local codes. in
absence of local codes, follow the
National Electrical Code, ANSI/
NFPA 70 (Latest Edition).
Blower
Blower Power
Cord
Figure 8 - Routing Blower Accessory
Power Cord for Conventional Installation
built-In Installation of blower Accessory
1. Install blower assembly per instruction sheet
included.
2. Before replacing bottom of firebox, remove screw
holding duplex outlet to the support bracket in
the bottom of firebox. Remove duplex outlet.
3. Clamp electrical cable into firebox through
smallest hole using strain relief provided.
4. Route wires from electrical box through hole
in side of heater and hole in support bracket
(see Figure 9).
107331-01J
Electrical
Outlet
Side
Opening
Support Bracket
Opening
www.desatech.com
5. Connect wires from the electrical box to
duplex outlet. Match wire colors to those
indicated on duplex outlet. Be sure to connect
ground wire.
6. Replace duplex outlet with screw.
7. Plug blower power cord into duplex outlet.
8. Replace bottom of firebox.
Blower
Support Bracket
Blower
Power Cord
Figure 9 - Routing Blower Accessory
Power Cord for Built-In Installation
operating the Blower
Light your gas appliance with the blower off. After
about 15 minutes, turn the blower on to deliver
heated air at the top louvers. The blower features
a variable control which allows you to select the
speed you desire.
Note: Periodically check the louvers of the firebox
and remove any dust, dirt or other obstructions.
INstAllING loG heAteR IN
FIRebox
Caution: Do not pick up log
base assembly by burners. this
could damage burners. only
handle base by grates.
cAutIoN: do not remove the
data plates attached to the heater
base assembly. the data plates
contain important warranty and
safety information.
1. Remove four screws holding firebox bottom
in place.
Cables From
Electrical Source
Duplex
Outlet
Screw