Comfort Glow CGFB32CA Installation Manual page 10

INSTALLATION
Continued
2. Lift and remove firebox bottom (see Figure 10).
3. If installing GA3750A blower accessory, see
Installing Blower Accessory, page 8.
4. Route flexible gas line from equipment shutoff
valve into firebox through side.
notiCe: Most building codes
do not permit concealed gas
connections. a flexible gas line
is recommended to allow acces-
sibility from the firebox. the flex-
ible gas supply line connection
to the equipment shutoff valve
should be accessible.
5. Attach gas log heater base to firebox bottom
with four screws included with base (see
Installing Heater Base Assembly in log set
owner's manual).
6. Replace firebox bottom and secure with
screws.
Figure 10 - Removing Firebox Bottom
INstAllING FIReplAce hood
notiCe: the firebox canopy (hood)
must not be modified or replaced
with a canopy (hood) that may be
provided with the unvented decora-
tive room heater.
1. Attach three zinc-colored shoulder screws to
back of hood.
2. Insert hood into hood-mounting slots on
firebox.
3. Hold hood in place. Insert two black Phillips
screws through bottom of hood and tighten.
10
Hood
Figure 11 - Installing Fireplace Hood
INstAllING FIReplAce scReeN
1. Insert each rod through nine rings located at
top of screen (see Figure 12).
2. Insert first rod into rear hole in left side of
firebox. Fasten rod to rear hole near center of
firebox using black shoulder screw.
3. Insert other rod into front hole on right side of
firebox and fasten using remaining shoulder
screw.
Front and
Rear Hole
Rod
Ring
Screen
Figure 12 - Installing Fireplace Screen
FIRebox INstAllAtIoN usING
optIoNAl AccessoRy mANtels
This firebox may be installed using the corner or
cabinet mantel with hearth base accessory against
a wall in your home. A trim kit is included with
each mantel accessory (see Accessories, page 12).
Follow the instructions included with mantels for
assembly and installation.
buIlt-IN FIRebox INstAllAtIoN
Built-in installation of this firebox involves in-
stalling firebox into a framed-in enclosure. This
makes the front of firebox flush with wall. Optional
perimeter trim is available (see Accessories, page
12) This perimeter trim will extend past sides of
firebox approximately 1/2". This will cover rough
edges of the wall opening. If installing a mantel
above the firebox, you must follow the clearances
shown in Figure 7, page 8. Follow the instructions
below to install the firebox in this manner.
www.desatech.com
Hood
Mounting
Slot
Shoulder
Screw
Screw
Screw
107331-01J