Osd Warning Messages - Dell 2407WFP User Manual

Documentation
Back
Mode
When
PIP/PBP
or
activated
PIP/PBP Sour
ce
Push
There is two modes: PIP (Picture in Picture) and PBP (Picture By Picture)
PIP Position
Use and
When PIP/PBP
PIP Size
Select an input signal for PIP/PBP. (VGA/DVI/S-Video/Composite/Component)
PIP/PBP Contr
Use and
ast
Select PIP window position.
Use and
PIP/PBP
Select PIP window size.
Hue/Tint
Use and
Adjust the contrast level of the picture in PIP/PBP Mode.
PIP/PBP
reduce the contrast
Saturation
increases the contrast
This function shifts the color of PIP/PBP image to green or purple. This is used to adjust for desired flesh tone color.
shifts image color towards green
Exit Menu
shifts image color towards purple
Adjust the color saturation of PIP/PBP image.
makes the image look more monochrome
makes the image look more colorful
Push

OSD Warning Messages

Your monitor will prompt you to achieve the best performance when you select PBP. You may see the following messages under certain combinations of input sources
in PBP mode.
http://support.dell.com/support/edocs/monitors/2407WFP/en/setup.htm
to go back to the main menu.
to browse and to select "Off", "PIP" or "PBP".
is activated select exchange the input source for the main screen and PIP/PBP window.
, "Swap" to
to browse and to select.
to browse and to select.
to browse and to select.
to exit the OSD main menu.
NOTE: When using DVI source, the contrast adjustment is not available.
or
Page 11 of 14
12/10/2007